X-10 X10 PRO XP4LS Installation And Operating Instructions Manual page 7

To Enter any Mode:
1) Press and hold down the PROGRAM button and release it when the LED starts
blinking green. You are now in Mode 1 (Setting New Primary Address).
2) Tap the PROGRAM button once. The LED is blinking red. You are in Mode 2
(Setting New Scene Addresses).
3) Tap the PROGRAM button once. The LED is blinking orange. You are in Mode 3
(Setting Channel Enables).
4) Tap the PROGRAM button once. The LED is alternating green and red. You are
in Mode 4 (Setting Ramp Rates).
5) Tap the PROGRAM button once. The LED is alternating green and orange. You
are in Mode 5 (Setting Advanced Programming Options).
LED Color Indicator
Program Mode
Mode 1
Mode 2
Mode 3
Mode 4
Mode 5
Mode 1 Programming - Setting the Primary Address
1) Enter Mode 1. See To Enter any Mode section.
2) Transmit X-10 address. This address will be the new Primary Address.
3) Press All-Lights-On key. The product stores new Primary Address into memory.
4) Press All-Lights-On key 3 times. The product is transferred out of programming
mode and into normal operation.
Mode Name
Normal Operation
Setting New Primary Address
Setting New Scene Addresses
Setting Channel Enables
Setting Ramp Rates
Advanced Programming Options
Page 7
LED Pattern
Solid Red
Blinking Green
Blinking Red
Blinking Orange
Alternating Green and Red
Alternating Green and Orange