Samsung ML-2015/XEV Service Manual page 71

Disassembly and Reassembly
6. Remove the thermo cap by releasing 2 screws as
shown as below.
(Screw x 2:Black_M3,6003-000282)
7. After pulling out the thermostat as shown as below,
remove the CBF harness from its left/right side.
Thermostat
8. Release the screw as shown as below, remove the
harness from the cover, and then pull out the thermistor.
(Screw x 1:Black_M3,6003-000196)
Note : Under the condition that the fuser is connected to the frame,the exit roller F/Down can be
separated.However,be careful that the Roller_Main,the Roller_FR,and F/Down Holder could get into the
inner frame due to the spring' action.
Service Manual
5-10
Thermo Cap
Thermistor
9. After separating the CBF harness connected to the
left/right side of the halogen lamp, release 2 screws
from the halogen lamp.
(Screw x 2:Black_M3,6003-000196)
10. Separate the Cover-M by releasing 2 screws as
shown as below.
(Screw x 2 : Black_M3, 6003-000196)
Cover-M
11. Remove the halogen lamp from the heat roller by
pulling it out to the arrow direction.
Halogen Lamp
Heat Roller
Samsung Electronics