Samsung ML-2015/XEV Service Manual page 69

Disassembly and Reassembly
5.2.8 RX Drive
1. Before Disassembling
-Separate the font cover.(Refer to 5.2)
-Separate the SMPS cover.(Refer to 5.3)
-Separate the Main cover.(Refer to 5.4)
2. Release 2 screws (Screw x 2:Silver_M3, 6001-
000130) connected to the engine shield and 6 screws
(Screw x 6: Gold_M3,6003-000296)connected to the
frame. Separate the RX drive by pulling it out toward
the arrow direction.
3. Remove the connector from the separated RX drive.
Note:
Service Manual
5-8
RX Drive
Please, be careful not to touch the protruding 4 screws at the out-
side of the RX drive.
4. After removing the RX drive,RDCN Gear, OPC Gear,
Fuser Gear, and Feed Gear can be removed from the
frame.
RDCN Gear
OPC Gear
Feed Gear
5. When separating the motor,remove the motor bracket
first by removing 4 screws as shown as below, and
then remove the 2 screws from the motor bracket.
Motor Bracket
Fuser Gear
Gear Bracket
RX Motor
Samsung Electronics