Table of Contents
Advertisement
Initial Set Menu
Registering New DVRs
You can register a new DVR by configuring the
DVR's IP address either automatically or
manually.
● Auto configuration mode
1
Select auto configuration mode on the
DVR's NETWORK SET screen.
On the NETWORK SET screen, set
[ADDRESS SET] to "AUTO".
< NETWORK SET - ADVANCED >
ADDRESS SET
DVR NAME
IP ADDRESS
SUB NET MASK : 255.255.255. 0
(The actual configuration screen differs
depending on the DVR model.)
2
Select "AUTO" from [TCP/IP ADDR.].
This activates the IP address auto
configuration mode.
3
Click
The system starts creating the
registration list, with the command
buttons on the windows temporarily
disabled.
4
Press and hold the [STILL] button on
the DVR's front panel.
Hold down the button until the DVR's
internal beeper chirps twice.
If the beeper outputs an intermittent
beep and then a continuous beep, it
means that the system has failed to
allocate an IP address. Try again after
making sure that the network
connections and configurations are
correct.
83
English
: AUTO
: DVR1
: 192.168. 0. 1
.
(Required user access level: ID4)
5
Review the registration information
displayed on the list.
When the process completes
successfully, an IP address is allocated
to the DVR, and the tree list and
registration list display the following
items.
• GROUP:
A newly registered DVR belongs to the
WORKGROUP group by default (but the
group can be changed).
• DVR NAME:
A newly registered DVR is by default
assigned a title that consists of the last
six digits (XX-XX-XX) of the MAC
address (but the title can be changed).
• TYPE:
The DVR's model is automatically
recognized and displayed.
• IP ADDR.:
The automatically allocated IP address
is displayed.
• MAC ADDR.:
The DVR's own MAC address is
automatically recognized and displayed.
6
Click
The command buttons are enabled.
7
If you have other DVRs you want to
register, repeat steps 1 to 6 above for
each of the DVRs.
8
Editing the Tree List
A newly registered DVR is associated
with default title and group, which you
can change as needed.
For more information, see P86.
In auto configuration mode, you
can specify in advance the group
to which the new DVR should
belong. To do so, click the desired
group (or an existing DVR that
belongs to the desired group)
before clicking the
button. This makes the newly
registered DVR belong to your
specified group, rather than the
default group.
9
Click
.
Your changes are saved and uploaded to
the DVR.
again.
Advertisement
Table of Contents
