Basic Operation; Ups On/Off; Lcd Features; Display Power Conditions - Tripp Lite ECO-UPS ECO850LCD Owner's Manual

Basic Operation

UPS ON/OFF

• P lug the UPS into a grounded outlet.
• T urn the UPS on: Press and hold the
once briefly after 2 seconds have passed.
• P lug equipment into the UPS: Select outlets will provide battery backup and surge
protection; connect your computer, monitor and other critical devices here.* Select outlets
will provide surge protection only; connect your printer and other nonessential devices
here.
• T urn the UPS off: Press and hold the
beep once after 2.5 seconds have passed.
* Your UPS is designed to support electronic equipment only. You will overload the UPS if the total VA ratings for
all the equipment you connect to the "Battery, Surge and Noise Protected" outlets exceeds the UPS's Output
Capacity. To estimate your equipment's power requirements, look on the nameplates. If the equipment is
listed in amps, multiply the number of amps by 120 to determine VA, (Example: 1 amp x 120 = 120 VA).
Your UPS is fully loaded when the display indicates 100% load.

LCD Features

Tap the button to advance from one display to the next. Use the
settings for ECO, Alarm, LCD Brightness and Self-test functions. When the preferred setting
has been selected, continue by pressing the
the LCD will return to the home screen, retaining the last selected settings.

Display Power Conditions

Use the button to advance through power conditions.
• Voltage In
• Voltage Out
• Estimated Runtime (in minutes)
• Load %*
• Load Wattage*
• Battery Capacity %
* Display measurement represents battery backup protected outlets only.

ECO Energy-Saving Feature

Use the included USB cable to connect your UPS to your computer. Connect nonessential
equipment to the ECO outlets, marked "ECO" on your UPS system. Make sure that any
devices connected to the ECO outlets can be turned off without interrupting your Internet
connection, local network, or other essential services. While your UPS is turned on and
operating normally from utility power, tap the
display to the screen marked "ECO". Use the

Enable/Disable Alarm

Tap the button repeatedly to advance to the LCD display featuring the
button to select enable or disable alarm mode settings.
201010198.indb 3
button for 2 seconds. The UPS alarm will beep
button for 2.5 seconds. The UPS alarm will
button. If the screen is idle for 20 seconds,
button repeatedly to advance the LCD
button to enable the ECO function.
3
button to toggle
icon. Press the
12/21/2010 11:47:34 AM