Dsub 15-Pin Accessory Connector - Vertex Standard VX-2200 Series Service Manual

DSUB 15-pin Accessory Connector

Pin 1: AF IN ( A
NALOG
External Microphone Input. Nominal input level is 6
mV at 600-ohm.
When connect the External Microphone to this port,
insert a 0.1 µF coupling capacitor between the micro-
phone and this port; as shown illustlation.
Pin 2: AF OUT ( A
NALOG
Low-level receiver output. Peak signal level is 150 mV
at 600-ohm.
Pin 3: AF GND
Ground for all logic levels and power supply return.
Pin 4: DC OUT ( 13.6 V DC O
Switched 13.6V output for supplying power to an ac-
cessory.
Pin 5: RSSI ( A
NALOG
A DC voltage proportional to the strength of the sig-
nal currently being received (Receiver Signal Strength
Indicator) is provided on this pin. This low impedance
output is gererated by the receiver IF sub-system and
bufferd by an internal op-amp. Typical output volt-
ages are 1 V (@No Signal Input) through 2.0 V (@50 dB
Signal Input).
B-1
)
I
NPUT
)
O
UTPUT
)
UTPUT
)
O
UTPUT
Pin 6: EXT PTT
Shorting this port to ground causes the transceiver to
be placed in the Transmit mode, while opening the
connection to this port returns the transceiver to the
Receive mode. Opening voltage is 5 V, closed current
approx. 5 mA.
Pin 7: TRX
This port is intended for controlling an external TX/
RX switching circuit. When the transceiver is placed
in the the Receiver mode, this port is 5 V. When the
transceiver is placed in the the Transmit mode, this port
reduse to 0 V.
Pin 8: IGN ( I
GNITION
The VX-2100/-2200 may be automatically be switched
to the STND-BY mode when the vehicle's ignition key
is turned on. Maximum current is 20 mA.
Pin 9 - 12: ACC1 - ACC4 (A
These port features can be programmed via the CE82
programmer. Each port is open collector output which
can sink approx. 100 mA when active. Max. output 16V.
When the input is selected, it becomes active between
2V and 16V.
Pin 13: ACC5 (A
CCESSORY
The port 5 is available to set only for Output function,
and active logic is the opposite side against the Port 1
~ 4.
Max.output 5V, closed current approx. 1 mA.
(CMOS output)
Pin 14: ACC6 (A
CCESSORY
The port 6 is available to set only for Input function,
and active logic is the opposite side against the Port 1
~ 4.
Max.input 5V. (CMOS input)
Pin 15: GND
Chassis ground
)
S
ENSE FEATURE
P
CCESSORY ORT
P )
ORT
P )
ORT
)