Table of Contents
Advertisement
Installation
1
Lower cooktop into cutout.
Connect the red and black leads from the unit conduit
3
Cooktop
Countertop
Filler
Block
Screw
Bracket
After placing cooktop in the cutout, screw brackets to
burner box with sheet metal screw. (Six bracket
assemblies included - 2 per side, 1 front, 1 rear)
Note: It is recommended to use a filler block between
prevent any damage to the countertop. Failure to do
so may result in cracking or splitting of the countertop.
12
2
Neutral
Green
Red
Black
to the corresponding leads in the junction box.
4
Cooktop
Countertop
Filler
Block
Eye Bolt
Bracket
Screw sheet metal screws into brackets
and tighten firmly against bottom of countertop.
the bolt and the underside of the countertop to
Final Preparation
• Some stainless steel parts may have a
plastic protective wrap which must be
peeled off.
• All stainless steel body parts should be
wiped with hot, soapy water and with a
liquid cleaner designed for this material.
If buildup occurs, DO NOT use steel wool,
abrasive cloths, cleaners, or powders!
Performance Checklist
A qualified installer should carry out the
Any adjustments necessary that are a result of
following checks:
the installer not following instructions will be
the responsibility of the installer, dealer of the
Check top surface elements
end user of this product.
n n
1. Check top surface elements – glow red
when turned on.
2. Check hot surface indicator lights – glow
red when corresponding element is hot.
13
If it is necessary to scrape stainless steel
to remove encrusted materials, soak with
hot, wet cloths to loosen the material,
then use a wood or nylon scraper.
DO NOT use a metal knife, spatula, or
any other metal tool to scrape stainless
steel! Scratches are almost impossible
to remove.
Advertisement
Table of Contents
