Yamaha DSP-AX863SE Owner's Manual page 35

7
Press 9 n to select "START" and then press
9 ENTER to start the setup procedure.
The following message appears in the OSD.
When this unit starts the automatic setup procedure,
loud test tones are output at the speakers.
For more accurate measurements, keep quiet and
move to the wall where speakers are not around. We
recommend that you leave the listening room during
the automatic setup procedure.
NOTICE
Loud test tones are
output.
Please keep quiet
or leave the room.
Press [ENTER]
Once you perform the next operation, this unit starts
the automatic setup procedure.
Press 9 ENTER to start the automatic setup
8
procedure.
The following screen appears in the OSD and setup
procedure starts in 10 seconds.
AUTO SETUP
Measurement Start
in 9 seconds
[RETURN]:Cancel
Loud test tones are output from each speaker during
the auto setup procedure. Once all items are set, the
"RESULT" display appears in the OSD.
Notes
• During the automatic setup procedure, do not perform any
operation on this unit.
• We recommend that you get out of the room while this unit
is in the auto setup procedure. It takes approximately 3
minutes for this unit to complete the auto setup procedure.
y
Press 9 k to cancel the automatic setup procedure.
Optimizing the speaker setting for your listening room (YPAO)
9
Make sure that the following screen appears
and then press 9 ENTER to display the
result screen.
AUTO SETUP
Measurement Complete
Press [ENTER]
AUTO SETUP
. RESULT
SP
DIST:
LVL : -9.0/+6.5dB
> SET
[ ]/[ ]:Up/Down
[ENTER]:Detail
The results displayed under "RESULT" are as
follows:
Number of speakers SP
Displays the number of speakers connected to this
unit in the following order:
Front/Back/Subwoofer
Speaker distance DIST
Displays the speaker distance from the listening
position in the following order:
Closest speaker distance/Farthest speaker distance
Speaker level LVL
Displays the speaker output level in the following
order:
Lowest speaker output level/Highest speaker output
level
Notes
• The signal output at the SUBWOOFER PRE OUT 2 jack
is the same as the one output at the SUBWOOFER PRE
OUT 1 jack. Therefore, even if you connect two
subwoofers, the number of the connected subwoofer is
indicated as "0.1".
• If "E-10:INTERNAL ERROR" appears during the testing
procedure, restart from step 4.
• If you selected other than "AUTO" in step 5, no test tones
are output.
• If an error occurs during the "AUTO SETUP" procedure,
the setup procedure is canceled and an error screen
appears. For details, see "If an error screen appears" on
page 35.
• When this unit detects potential problems during the
"AUTO SETUP" procedure, "WARNING" and the
number of warning messages appears in the above of
"RESULT" (see page 35).
• Depending on the listening environment, "SWFR
PHASE:REV" appears during the automatic procedure
and "SUBWOOFER PHASE" in "SOUND MENU" (see
page 70) is automatically set to "REVERSE".
: 3/4/0.1
4.50/5.30m
CANCEL
33
En