Accessories / Maintenance - Vax ALL TERRAIN V-125 Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

NOTE: Make no more than 2 passes with the solution

or rinse over any one area to prevent over-wetting and

damage to fabric.

If additional cleaning is necessary, wait until the

upholstery is completely dry before using the tool again.

Empty recovery tank when the motor sound becomes

higher pitched and there is a loss in suction (see

"Automatic shut-off", Fig. 4/5).

When finished cleaning, follow "After cleaning"

instructions on page 10 and "After using tool" instructions

on page 14.

7. Maintenance

After Cleaning

Allow carpet or upholstery to dry. To help prevent matting

and resoiling the carpet, keep children and pets away from

surface until it is completely dry. If it is necessary to walk

on damp carpet, place towels or white cloths on the traffic

areas. If furniture must be replaced before the carpet is

dry, place plastic or aluminum foil under legs of furniture so

metal slides or wood finishes will not stain the

carpet.

Empty tanks, rinse with clear water and let air dry. Rinse

the recovery tank lid and let air dry. Any unused solution

may be left in the solution container for future use.

Remove lint from filter screen located inside recovery tank.

(Fig.7/1).

Fig.7/1

Remove lint from filter screen located on bottom of

cleaner (Fig.7/2).

Fig.7/2

NOTE: When brushes seem to be rotating slowly,

disconnect cleaner from electical outlet and check and

clean this screen.

Remove both tanks as described in Fig 4/9 & Fig 4/10. Tilt

cleaner back so handle rests on floor.

Squeeze filter frame, lift and pull it out. Wipe off screen

and push frame back into place. Return cleaner to upright

position.