Vauxhall Combo Quick Reference Manual page 2

Vehicle features
Seat position adjustment: Backrest adjustment:
Pull handle, slide seat, release handle Turn handwheel to adjust backrest to
and allow seat to audibly latch into a suitable position. Do not lean on
position. backrest whilst adjusting it.
Folding down front passenger's Adjusting head restraint height 3:
:
seat backrest 3
Tilt forwards to release, hold firmly and
Push passenger seat head restraint adjust height, then release.
down or remove.
Important: Do not sit nearer than
Fold front passenger seat forward by
10 inches (25 cm) from steering wheel
raising release lever.
to permit safe airbag deployment.
Fitting the seat belt: Electrically operated door windows 3:
Draw smoothly from inertia reel, guide Two rocker switches in the driver's door
over shoulder and engage in buckle. handle for the driver and front
passenger's side door windows.
The belt must not be twisted at any
point. The lap belt must fit snugly Additional switch in the front
across the body. The seat backrest passenger's door handle.
must not be tilted too far back
To operate window in stages, tap
(recommended maximum tilting angle
appropriate switch. For automatic
approx. 25 degrees).
opening or closing, keep switch pressed
To release belt, press red button on slightly longer. To stop window
belt buckle. movement, tap switch again.
Adjust seat height:
Pull lever at side and remove weight
from seat to raise it or press down on
seat with body weight to lower it.
Adjusting steering wheel position 3:
Swivel lever down, adjust height, swivel
lever up, engage into position.
Adjust steering wheel only when vehicle
is stationary and steering column lock is
released.
Electrically adjustable
exterior mirrors 3:
Four-way switch in driver's door handle.
Toggle switch to left or right: four-way
switch moves appropriate mirror.
Vehicle features
Switching on dipped or main beam: Operating turn signal lights:
Main beam = Push stalk forwards Stalk in rest position
Dipped beam = Push forwards again.
Right turn = Upwards
Left turn = Downwards
Headlight flash:
When the steering wheel is turned back,
Pull stalk towards steering wheel.
the stalk automatically returns to its
original position.
This will not happen when making a
minor steering manoeuvre such as
changing lanes.
When lane changing, move stalk to
resistance point.
When released, stalk will spring back.
Operating windscreen wash system:
Windscreen wiper:
Pull stalk towards steering wheel.
Move stalk up
Wash fluid is sprayed onto the
§ = Off
windscreen; at the same time the
$ = Adjustable timed interval wipe
wiper is operated for several cycles.
% = Slow
& = Fast
Setting wiper interval to a value between
2 and 15 seconds:
z Set stalk to timed interval wipe $
z Set stalk to §
z Wait for desired interval
z Set stalk to timed interval wipe $
The interval remains stored until next
change or until ignition is switched off.
Switching ignition off and moving stalk
to $ sets interval to 7 seconds.
Engine oil: Refuelling:
Check every 600 miles and prior to long Use unleaded fuel for petrol engines.
journeys. Fuel tank capacity = 52 litres.
Important: It is the owner's responsibility
to maintain the correct level of an
appropriate quality oil in the engine.
Hazard warning lights:
On = Press ¨
Off = Press ¨ again
To aid location of the pushbutton, the
red surface is illuminated when the
ignition is switched on. When the button
is pressed, its control indicator flashes in
time with the hazard warning lights.
:
Rear window wiper and wash system 3
Wiper on = Push stalk forwards
Wiper off = Pull stalk towards
steering wheel
Wash = Push stalk forwards
and hold
The rear window wiper operates in
timed interval mode.
The wiper will swipe for a few strokes
when washing.
Warning:
In freezing conditions, wiper blades can
freeze to windscreen. Release blades
from the ice before operating
windscreen wiper to prevent wiper motor
damage.