Electrical Parking Brake; Accelerator Pedal; Clutch Pedal - Vauxhall Meriva Owner's Manual

130 Driving and operating
Parking brake

Electrical parking brake

Applying when vehicle is stationary
Pull switch m, the electrical parking
brake operates automatically with
adequate force. For maximum force,
e.g. parking with trailer or on inclines,
pull switch m twice.
The electrical parking brake can
always be activated, even if the
ignition is off.
Do not operate electrical parking
brake system too often without
engine running because this will
discharge the battery.
Before leaving the vehicle, check the
electrical parking brake status.
Control indicator m 3 86.
Releasing
Switch on ignition. Keep foot brake
pedal depressed and then push
switch m.
Drive away function
Depressing clutch pedal (manual
transmission) or engaging D
(automatic transmission) and then
depressing the accelerator pedal
releases the electrical parking brake
automatically. This is not possible
when the switch is pulled at the same
time.
This function also helps driving away
on inclines.
Aggressive drive away may reduce
life time of wear parts.
Dynamic braking when vehicle is
moving
When the vehicle is moving and the
switch m is kept pulled, the electrical
parking brake system will decelerate
the vehicle, but will not apply
statically.
As soon as the switch m is released,
dynamic braking will be stopped.
Fault
Failure mode of electrical parking
brake is indicated by control indicator
j and by a code number or a vehicle
message which is displayed in the
Driver Information Center. Vehicle
messages 3 94.
Apply electrical parking brake: pull
and hold the switch m for more than
5 seconds. If control indicator m
illuminates, electrical parking brake is
applied.
Release electrical parking brake:
push and hold the switch m for more
than 2 seconds. If control indicator
m goes out, electrical parking brake
is released.