Vauxhall Insignia Owner's Manual page 47

46 Seats, restraints
Storing memory positions by buttons
1 and 2
■ Adjust driver's seat and then adjust
exterior mirrors to desired
positions.
■ Press and hold button MEM and
button 1 at the same time until a
beep sounds.
■ Repat the steps for a second driver
using button 2.
Recall of memory positions
Keep position button 1 or 2 pressed
until the stored seat and exterior
mirror positions have been reached.
Releasing the button during moving
stops the recall.
Storing positions by remote control
Actual driver's seat and exterior
mirror positions are automatically
stored by the radio remote control key
each time the ignition is switched off.
These stored positions are
independent of the memory positions
stored by the buttons 1 or 2, see
above.
The stored positions are
automatically recalled by unlocking
and opening the driver's door with the
memorised radio remote key. If the
door is already open, press button c
on remote control to activate the
recall.
To stop recall movement, press one
of the memory-, power mirror- or
power seat controls.
Activation or deactivation of this
function can be changed in the menu
Settings in the Info-Display. Vehicle
personalisation 3 111.
Easy exit function
For a convenient exit out of the
vehicle, the power driver seat moves
rearwards when vehicle is stationary.
To activate, switch off ignition,
remove key from the ignition switch
and open the driver's door. If the door
is already open, switch off ignition to
activate the recall.
To stop recall movement, press one
of the memory- or power seat
controls.
Activation or deactivation of this
function can be changed in the menu
Settings in the Info-Display. Vehicle
personalisation 3 111.
Safety function
If the driver's seat encounters
resistance during movement, the
recall may stop. After removing the
obstruction, operate and hold the
appropriate power seat position
button for the memory item manually
for two seconds. Try recalling the
memory position again. If the recall
does not operate consult a workshop.
Overload
If the seat setting is electrically
overloaded, the power supply is
automatically cut-off for a short time.
Note
After an accident in which airbags
have been deployed, the memorised
settings for each position button will
be deactivated.