Audio Recording - Canon MVX350i Instruction Manual

Audio Recording

Changing the Audio Mode
You can record sound in two audio modes—16-bit and 12-bit. The 12-bit mode records
sound on two channels (stereo 1), leaving 2 channels free (stereo 2) for adding new
sound later. Select the 16-bit mode for higher sound quality.
CAMERA
* MVX350i/MVX330i only.
MENU
AUDIO SETUP
( 37)
Open the menu and select [AUDIO SETUP]. Select [AUDIO MODE], set it
to [16bit] and close the menu.
"16bit" appears for approximately 4 seconds.
Using Headphones during Recording
The headphones terminal also serves as AV terminal. Headphones can only be used
when " " is displayed on the screen. If not, change the setting following the procedure
below.
CAMERA
MENU
VCR SETUP
( 37)
Open the menu and select [VCR SETUP]. Select [AV/PHONES
[PHONES ] and close the menu.
Adjusting the Headphone Volume
CAMERA
MENU
AUDIO SETUP
( 37)
Open the menu and select [AUDIO SETUP]. Select [ VOLUME], adjust
the volume with the SET dial and close the menu.
You can turn off the volume completely by turning the SET dial down until [OFF] appears.
Turn the SET dial up to increase the volume again.
60
*
PLAY (VCR)
PLAY (VCR)
PLAY (VCR)
CARD CAMERA
AUDIO MODE•••12bit
CARD CAMERA
AV/PHONES ••AV
CARD CAMERA
VOLUME•••••
CARD PLAY
CARD PLAY
], set it to
CARD PLAY