Advertisement
"ndow Mounting
g
Remove
Chassis
1. Pull down front panel and remove filter. (See FIG. 1).
2. Lil_ front upwards and place to one side.
D
Install
Top Angle
and Side Bracket
1.
Attach foam gasket to top angle above holes as
shown in FIG. 6.
3. Locate the four front screws and remove. These screws
will be needed to re-install the front later. (See FIG.2)
4. Pry away front from cabinet sides as per photo (see FIG .3)
5. Gently lift front off unit and place to one side (See FIG.4).
2. Install top
angle and
side retainers
to cabinet as
shown in FIG. 6.
FIG. 6
6. Removeshi ppingcrewsfrom
top d unit and_tso on theside
by the base if installed.
7. Hold the cabinet while pulling on the base handle, and
carefully remove the unit.
8. Add two foam inserts to holes in top of cabinet where
shipping screws were removed from.
Assemble
Window
a
Filler Panels
1.
Place cabinet on floor, a bench, or a table.
2.
Slide 'T' section of window filler panel into side retainer
on the side of the cabinet (see Figures 7-8). Do both
sides.
FIG. 7
PLASTIC
WINDOW FILLER
FRAME
PANEL
9. Your unit may come with internal packaging.THIS
PACKAGING
MUST BE REMOVED PRIOR TO
INSTALLING THE AIR CONDITIONER
BACK
INTO THE CABINET. (See FIG. 5).
FIG. 8
TOP
VIEW
SIDE
RETAINER
PLASTIC
FRAME
LOCKING
'T'SECTION
WINDOW
SCREW
HOLE
FILLER
PANEL
3
Advertisement
