Checking The Needle Drop Point With The Embroidery Foot "W+" With Led Pointer - Baby Lock Spirit BLPY Instruction And Reference Manual

b
Hold the embroidery foot in place with
your right hand, and then use the included
screwdriver to securely tighten the
embroidery foot screw.
CAUTION
• Use the included screwdriver to firmly tighten
the screw of the embroidery foot. If the screw
is loose, the needle may strike the embroidery
foot and possibly cause injury.
c
Plug the connector of the embroidery foot
"W+" with LED pointer into the jack on the
back of your machine.
d
Press to unlock all keys and
buttons.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.
CHANGING THE EMBROIDERY FOOT
■ Checking the Needle Drop Point
With the Embroidery Foot "W+"
with LED Pointer
Before beginning to embroider when using the
embroidery foot "W+" with LED pointer, carefully
read the procedures described in the "Embroidery"
and "Embroidery Edit" chapters.
a
Press in the embroidery screen.
→ The LED pointer indicates the needle drop point.
Memo
• When the LED pointer is turned on, the
presser foot height is automatically adjusted
according to the fabric thickness.
• If is pressed again, the fabric thickness
is remeasured and the presser foot is set to
the optimum height.
* The LED pointer turns off automatically by lowering
the presser foot or returning to the previous page.
Note
• With bulky fabrics, the position may not be
accurate due to the various depths of the
fabrics. In this case, manually adjust the
position according to the thickness of the
fabric.
• With fabric that has a very uneven surface
such as quilting, the fabric thickness may
not be correctly measured. In this case, the
pointer indication should be used only as a
reference.
Basic operations B-47
B
1