2-Thread Flatlock - Narrow - Baby Lock Evolution BLE8W-2 Instruction And Reference Manual

2-Thread Flatlock - Narrow

Sew a 2-thread flatlock seam then pull the two fabric layers apart
until the seam lies flat (fig. A).
Because the threads show on the outside as well as the inside of the
garment or project, the flatlock seam is often considered a decora-
tive application (fig. B).
For 2-thread flatlock - narrow
1. Engage the threading lever in threading position.
2. Place needle thread on "OVERLOCK NEEDLE 2" spool pin
3. Thread needle thread through the upper looper thread guide on
top of the machine, then go down the thread path in the front of
the machine. Go left with the needle thread at the hook on front
of the machine. Then take the needle thread through the normal
needle thread paths (see illustration below).
4. Engage the subsidiary looper (following step 3 on page 35).
5. Thread the lower looper as shown in the illustration below.
6. Engage the threading lever in the serging position.
Before serging, select stitch pattern you want to have on the outside of the garment.
For "loops" (lower looper thread) to show, place fabric wrong sides together for sewing the seam (fig. C).
To produce the "ladder" (needle thread) on the outside, place the fabric right sides together (fig. D).
For 2-thread flatlock-narrow, follow the suggested settings and the threading diagram below.
Wrong
side
Needle
Thread
Right
Side
NEEDLES
O-2
Loop
Right
Side
Looper
Thread
C
Wrong
Side
LENGTH
WIDTH
3 - 3.5
3.5
Right Ladder
Side
Right
Side
Wrong
Side
Wrong
Side
STITCH
SELECTOR
SELECTOR
OVERLOCK
B
O
V
A E
R
L
O
C
K
B
S
T
I
T
C
H
E
S
D
E
WAVE
X
P
R
E
S
S
37