Clearing The Stitch Width Fingers; Re-Threading Loopers - Baby Lock Evolution BLE8W-2 Instruction And Reference Manual

Clearing the Stitch Width Fingers

T
H
R
E
A
D
A
I
N
G
B

Re-threading Loopers

If a thread breaks, raise the presser foot and pull the broken thread out from under the foot. Open the front
cover and engage the threading lever (page 19). Re-thread the machine above the threading port, leaving an
18inch (45cm) thread tail. Thread the looper as usual then engage the threading lever to the serging position,
(page 20/21). Close the front cover and sew a test sample.
Note: When re-threading your Baby Lock Evolution using the "Extraordin Air Threading" feature, make sure
that the previous thread that was in the looper (tube) is completely removed. This will eliminate any chance of
the previous thread obstructing the flow of the air when re-threading the machine.
26
As you sew, you will discover that maneuvering the fabric is different from
conventional sewing because the threads form around the stitch fingers (fig.
A).
To clear the stitch fingers, simply raise the presser foot, which releases all
threads. Raise the needle(s). Then pull the threads gently from behind the
foot (fig. B). The stitches are now released from the fingers (fig. C).
C