FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause interference to radio communications.
VS-0404 User Manual Online Registration International http://support.aten.com North America http://www.aten-usa.com/product_registration Telephone Support International 886-2-8692-6959 China 86-10-5255-0110 Japan 81-3-5323-7178 Korea 82-2-467-6789 North America 1-888-999-ATEN ext 4988 United Kingdom 44-8448-158923 Technical Support For international online technical support – including troubleshooting, documentation, and software updates: http://support.aten.com...
Page 5
Overview The VS-0404 Video Matrix Switch combines the capability of a video switcher and signal splitter. It duplicates and enhances the video and audio signals from up to four input sources (computers), and routes them to up to four output devices (monitors, projectors, etc.).
Features Front panel push button switches select the combination of video input to video output. Duplicates and enhances video signals up to 65 m (max.) Cascadable Audio enabled Installation Requirements A VGA, SVGA, XGA or Multisync monitor capable of the highest resolution that you will be using on any computer in the installation for each output port you will be using.
Page 7
Components VS-0404 Front View 1 & 2 Component Description Input Select Each switch corresponds to an output port. Switches Pressing the switch cycles through the input sources to select which input source’s signal will be sent to the switch’s corresponding output port.
Page 8
VS-0404 Rear View Description Function Video / Audio The video and audio cables from the monitor Output Ports and speakers plug in here (bottom row). Power Jack The Power Adapter cable plugs in here. Video / Audio The video and audio cables from the Input Ports computer’s video and audio output ports plug...
2. Make sure that all devices you will be connecting up are properly grounded. Single Stage Setting up the VS-0404 is simply a matter of plugging in the cables. Refer to the installation diagram on the next page (the numbers in the diagram correspond to the numbered steps) and do the following: 1.
Page 10
5. Plug the power adapter that came with the VS-0404 into an AC power source, then plug the power adapter cable into the switch’s Power Jack. After you are all cabled up, you can power on the attached equipment. - 10 -...
Page 11
To cascade a video splitter, use a high density HDB-15 male/ female VGA cable to connect any available video out port on the VS-0404 to the video in port of the cascaded video splitter, as shown in the diagram below:...
The VS-0404 operates according to the following parameters: Each front panel pushbutton switch corresponds to an output port on the VS-0404’s rear panel. The switch is used to select the input source for the data that will be sent to its corresponding output port.
Vertical Sync Ground Ground Getting Help If you need to contact ATEN technical support with a problem, visit our website at www.aten.com. Limited Warranty IN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY EXCEED THE PRICE PAID FOR THE PRODUCT FROM THE DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE PRODUCT, DISK OR ITS DOCUMENTATION.