Auto-Negotiation; Mac Address Table - Planet FNSW-1600S User Manual

5.4 Auto-Negotiation

The 100Base-TX ports on the Switch have built-in "Auto-
Negotiation". This technology automatically sets the best
possible bandwidth when a connection is established with
another network device (usually at Power On or Reset). This is
done by detect the mode and speed at the second device is
capable of. The 100Base-TX devices can connect with the
100Base-TX port in either Half- or Full-Duplex mode.
If attached device is:
100Mbps, no auto-negotiation
100Mbps, with auto-negotiation
10Mbps, no auto-negotiation
10Mbps, with auto-negotiation

5.5 MAC Address Table

This 6-byte ID is called the MAC (Media Access Control)
Address. Every Ethernet data packet includes both source and
destination addresses.
The Switch can automatically learn and store up to 8K MAC
addresses. The MAC address table is volatile: it disappears
when the switch is powered off or reset.
Note: When the network needs reconfiguration, we
recommend turning off the power first. After all
nodes have been moved, power on the switch to
rebuild the internal MAC address table.
FNSW-1600S User's Guide
100Base-TX port will set to:
100Mbps
(100Base-TX, Half-Duplex)
200Mbps
(100Base-TX, Full-Duplex)
10Mbps
(10Base-T, Half-Duplex)
20Mbps
(10Base-T, Full-Duplex)
27