DISPLAY SETUP
To access DISPLAY SETUP, press ENTER button after moving highlight bar to this item in MAIN MENU.
Below menu will appear on monitor.
DISPLAY SETUP
1
ADJUST CHANNEL
BRIGHTNESS
CONTRAST
PTZ TYPE
2
SEQ DWELL TIME
3
TIME/ DATE OSD
4
CAM NUMBER OSD
5
VIDEO LOSS OSD
6
POP-UP DISPLAY
7
POSITION
ENTER
1) ADJUST CHANNEL:
Select the camera channel to adjust brightness, contrast or PTZ type.
BRIGHTNESS:
BRIGHTNESS can be changed using LEFT or RIGHT button
ë
Higher percentage shows brighter image.
Note
CONTRAST:
CONTRAST can be changed using LEFT or RIGHT button.
PTZ TYPE (Pan, Tilt and Zoom protocol selection)
Each camera has its own control protocol to control panning, tilting and zooming, according to PTZ
camera manufacturer. In order to control PTZ camera from remote area by DVR utility, proper PTZ
TYPE should be selected here.
ë
Currently support Panasonic/ Pelco-D/ PelcoP/ Techwin/
Note
Niko/ DRX502A_DSC230s /KRE_301_302/ GC_755_NP/ TOA_CC554/
RAS716LS / LPT-100 / KD.
2) SEQ DEWLL TIME:
It is the period of sequential display mode.
NOTE: It is just reflected in sequential display mode.
3) SPOT DWELL: 1 to 60 seconds.
▲ ▼ ◀ ▶
CH1 / CH2 / CH3 /CH4
1 to 99 %
1 to 99 %
NONE/ 1 to 60 seconds.
CH1
1-99 %
1-99 %
NONE, 1-60 SEC
ON/ OFF
ON/ OFF
ON/ OFF
ON/ OFF
EXIT
16