TP-Link TL-WDR3600 User Manual page 24

3) If the connection type detected is Static IP, the next screen will appear as shown in Figure
3-10. Configure the following parameters and then click Next to continue.
IP Address - This is the WAN IP address as seen by external users on the Internet

(including your ISP). Your ISP will provide you with the IP address you need to enter
here. Enter the IP address into the field.
Subnet Mask - The Subnet Mask is used for the WAN IP address. Your IPS will provide

you with the subnet mask which is usually 255.255.255.0.
Default Gateway - Your ISP will provide you with the Gateway address which is the ISP

server's address. Enter the gateway IP address into the box if required.
Primary DNS - Enter the DNS Server IP address into the box if required.

Secondary DNS - If your ISP provides another DNS server, enter it into this field.

5. After finishing WAN Connection Type selection, the Dual Band Selection page will appear as
shown in Figure 3-11. Here we choose "Concurrently with 2.4GHz and 5GHz (802.11a/b/g/n)"
for introduction. Click Next to continue.
2.4GHz - You can use the 2.4GHz band to connect to many classic wireless devices like

gaming consoles, laptops, DVRs, ect.
TL-WDR3600
Figure 3-10 Quick Setup - Static IP
Figure 3-11 Quick Setup – Dual Band Selection
N600 Wireless Dual Band Gigabit Router
- 14 -