Panel Layout - TP-Link TL-WR700N User Manual

1.4 Panel Layout

LED
Status
On
Flashing
Off
LAN/WAN: This LAN/WAN port works as LAN in AP/Repeater/ Bridge/Client mode and as
WAN in Router mode. As LAN, it connects the Router to the local PC; as WAN, it enables
you connect the DSL/cable Modem, or Ethernet.
RESET：It is used to reset the Router to its factory defaults. With the Router powered on,
use a pin to press and hold the RESET button (about 5 seconds) until the SYS LED
becomes quick-flash from slow-flash. And then release the button and wait the Router to
reboot to its factory default settings.
Power Plug: Plug in standard electrical wall socket directly to power the Router.
TL-WR700N
Figure 1-1 TL-WR700N sketch
The system is working properly.
The LAN/WAN cable is connected.
The system is working improperly, please check the
device connection.
Table 1-1 The LED Description
- 4 -
150Mbps Wireless N Mini Pocket Router
Indication