Table of Contents
Advertisement
SRM-225
2. Choke
Move choke lever (B) to Cold Start Position (
3. Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5
times.
Note: Energy is stored in the starter spring each time the
handle/rope is pulled. Generally two to six pulls, using
light pulling force, will store enough energy to engage the
starter and spin the engine. Do not pull the rope out to
end stop.
4. Recoil Starter
Lay the unit on a flat area and keep movable attachment parts clear of all obstacles. Firmly grasp right hand
grip and throttle trigger lockout with left hand, and fully depress throttle trigger to wide open position. Gently
pull starter handle/rope (D) until engine fires or 2 to 3 engine engagements.
5. Choke
After engine fires or 2 to 3 engine engagements, move choke
lever (B) to Run position (
throttle trigger lockout fully depressed, and pull recoil starter
starter handle/rope until engine starts and runs. Release
throttle trigger, and allow unit to warm up at idle for several
minutes.
Note: If engine does not start with choke in "Run" position after
2-3 engine engagements, repeat instructions 2 - 5.
6. Throttle Trigger
After engine warm-up, gradually depress throttle trigger to increase engine RPM to operating speed.
Starting Warm Engine
The starting procedure is the same as Cold Start except DO
NOT close the choke, and do not hold throttle trigger fully
depressed.
The attachment should not move at idle, otherwise serious
personal injury may result.
Note: If attachment moves, readjust carburetor according to
"Carburetor Adjustment" instructions in this manual or
see your ECHO Dealer.
X7722273305
© 4/2013 ECHO Inc.
).
). Hold throttle trigger and
B
C
D
A
OPERATION
19
Advertisement
Table of Contents
