Fuel Filter; Spark Plug - Echo PB-460LN Operator's Manual

FUEL FILTER

Level 1.
Parts required: Tune Up Kit
DANGER
Fuel is VERY fl ammable. Use extreme care when mixing, storing
or handling.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the "fuel line hook" to pull the fuel line and fi lter from the
tank.
3. Remove the fi lter from the line and install the new fi lter.
NOTE
Federal EPA regulations require all model year 2012 and later gaso-
line powered engines produced for sale in the United States to be
equipped with a special low permeation fuel supply hose between
the carburetor and fuel tank. When servicing model year 2012 and
later equipment, only fuel supply hoses certifi ed by EPA can be
used to replace the original equipment supply hose. Fines up to
$37,500 may be enforced for using an un-certifi ed replacement part.

SPARK PLUG

Level 2.
Parts Required: Tune Up Kit
IMPORTANT
Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada)
otherwise severe engine damage may occur.
1. Remove spark plug cover and spark plug, check for fouling, worn
and rounded center electrode.
2. Clean the plug or replace with a new one. DO NOT sand blast to
clean. Remaining sand will damage engine.
3. Adjust spark plug gap by bending outer electrode.
4. Tighten spark plug to 150-170 kgf • cm (130-150 in • lbf).
5. Install spark plug cover.
IMPORTANT
Always reinstall spark plug cover, otherwise engine cooling will
be greatly reduced, and engine failure will result.
P B
OWER LOWER
O ' M
PERATOR S
0.65 mm
(0.026 in.)
17
ANUAL