Echo PB-413H Operator's Manual
Echo power blower operator's manual
Hide thumbs
Also See for PB-413H:
- Operator's manual (28 pages) ,
- Starting instructions (2 pages) ,
- Parts catalog (38 pages)
Table of Contents
Advertisement
Power Blower
Operator's Manual
MODELS
Read rules for safe operation and all instructions carefully. ECHO provides this Operator's
Manual which must be read and understood for proper and safe operation.
X7501127900
PB-413H
Serial Number 02001001 - 02999999
PB-413T
Serial Number 02001001 - 02999999
WARNING
DANGER
X750005310
01/03
Advertisement
Table of Contents
Related Manuals for Echo PB-413H
Summary of Contents for Echo PB-413H
- Page 1 Power Blower Operator's Manual MODELS Read rules for safe operation and all instructions carefully. ECHO provides this Operator's Manual which must be read and understood for proper and safe operation. X7501127900 PB-413H Serial Number 02001001 - 02999999 PB-413T Serial Number 02001001 - 02999999...
-
Page 2: Table Of Contents
NTRODUCTION Welcome to the ECHO family. This ECHO product was designed and manufactured to provide long life and on-the-job- dependability. Read and understand this manual. You will find it easy to use and full of helpful operating tips and SAFETY messages. -
Page 3: Manual Safety Symbols And Important Information
If a decal cannot be read, a new one can be ordered from your ECHO dealer. See PARTS ORDERING instructions for specific information. GENERAL WARNING DECAL (located on top of blower housing) -
Page 4: International Symbols
PERSONAL CONDITION AND SAFETY EQUIPMENT Power Blower users risk injury to themselves and others if the Power Blower is used improperly and/or safety precautions are not followed. Proper clothing and safety gear must be worn when operating a Power Blower. -
Page 5: Extended Operation/Extreme Conditions
NOT operate unit if leaks are found. • Do not use blower if any part is missing or damaged. • Have repairs done only by an authorized ECHO Service dealer. • Do not use any attachment, accessory or replacement part unless it is recommended in this Operator's Manual. -
Page 6: Safe Operation
• Take wind conditions into account: avoid open doors and windows. • Provide all operators of this equipment with the Operator's Manual and instructions for safe operation. • Do not point blower at people or animals. Keep A Firm Grip • Hold handles with fingers together encircling handles. -
Page 7: Description
__ 1 - Straight Pipe __ 1 - Curved Pipe __ 1 - Operator's Manual __ 1 - Warranty Registration Card __ 1 - ECHO Emissions and Warranty Statement __ 1 - Plastic Bag 2 - Clamps w/screws 1 - Stick Handle... - Page 8 10. THROTTLE POSITION LEVER/STOP SWITCH - Combination stop switch and variable speed throttle lever. When the lever is moved all the way forward the blower is at Wide Open Throttle (W.O.T.). When the lever is moved rearward to detent, the blower is at idle. When the lever is moved rearward past the idle detent the blower will stop.
-
Page 9: Contents (Pb-413T)
__ 1 - Straight Pipe __ 1 - Curved Pipe __ 1 - Operator's Manual __ 1 - Warranty Registration Card __ 1 - ECHO Emissions and Warranty Statement __ 1 - Plastic Bag 2 - Clamps w/screws 2 - Cable Ties... - Page 10 14. THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration, press trigger gradually for best operating technique. 15. BLOWER PIPES - Twist lock design. 16. FLEXIBLE PIPE - Allows for full range of movement. ) (starting position) and for emergency stopping. Move DOWN to...
-
Page 11: Specifications
Exhaust System -------------------------------------------- Spark Arrestor Muffler w/catalyst Fuel ---------------------------------------------------------- Mixed (Gasoline and Two-stroke Oil) Fuel/Oil Ratio ----------------------------------------------- 50:1 ECHO High Performance, two-stroke air cooled engine oil Gasoline ----------------------------------------------------- 89 Octane unleaded. DO NOT use fuel containing methyl alcohol, more than 10% ethyl alcohol or 15% MTBE. -
Page 12: Assembly
1. Assemble clamps (A) onto both ends of flexible pipe (B). 2. Assemble straight pipe with swivel (C) into flexible pipe (B). 3. Assemble flexible pipe (B) to elbow (D) on blower. NOTE A light lubricant may be used to ease assembly of flexible pipe to blower elbow. -
Page 13: Install Blower Pipes (Pb-413T)
Remove clamp screw (D) on handle (E). Spread clamp and install onto straight pipe with swivel (C). 4. Assemble flexible pipe (B) to elbow (G) on blower. NOTE A light lubricant may be used to ease assembly of flexible pipe to blower elbow. -
Page 14: Pre-Operation
50:1 oil meets these standards. Engine problems due to inadequate lubrication caused by failure to use an ISO-L-EGD and J.A.S.O. FC certified oil, such as Echo Premium 50:1 Two-stroke Oil, will void the two-stroke engine warranty. (Emission related parts only are covered for two years, regardless of two-stroke oil used, per the statement listed in the Emission Defect Warranty Explanation.) -
Page 15: Operation
• Recoil starter: Use short pulls - only 1/2-2/3 of rope length for starting. Do not allow the rope to snap back in. Always hold the unit firmly. • (PB-413H): Rotate spring loaded throttle arm downward to a comfort- able operating position. STARTING COLD ENGINE PB-413H 1. -
Page 16: Starting Warm Engine
Slide stop switch (B) to Stop position. WARNING If engine does not stop when stop switch is moved to STOP position, close choke - COLD START position - to stall engine. Have your ECHO dealer repair stop switch before using blower again. PB-413H PB-413H... -
Page 17: Operating Blower
Always wear safety glasses, hearing protection, a face filter mask and take all safety precautions or serious personal injury may result. Do not point the blower pipe in the direction of people or pets. Read the Safety Section on pages 4 - 6 carefully. -
Page 18: Maintenance
ECHO Service Dealer for maintenance. To help you decide whether you want to DO-IT-YOURSELF or have the ECHO Dealer do it, each maintenance task has been graded. If task is not listed, see your ECHO Dealer for repairs. -
Page 19: Air Filter
AIR FILTER Level 1. Tools required: 25 - 50 mm (1 - 2 in.) medium bristle paint brush. Parts required: Tune Up Kit P/N 90070 NOTE Clean daily. 1. Close choke (Cold Start Position). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from the air cleaner area. -
Page 20: Spark Plug
Removal of cooling passage blockages or cleaning of cooling fins is considered “Normal Maintenance”. Any failure attributed to lack of maintenance is not warranted. Cleaning Grill 1. Remove accumulated debris from intake grill between backpack frame and blower housing. 0.65 mm (0.026 in.) -
Page 21: Exhaust System
The cylinder exhaust port must be inspected and cleaned of excess carbon every 3 months or 90 hours of operation in order to maintain this engine within the emissions durability period. ECHO strongly recommends that you return your unit to your ECHO dealer for this important maintenance service. OWER... -
Page 22: Carburetor Adjustment
High Altitude Adjustment High altitude adjustment is not required for proper operation of this engine. Level 2. Tools required: Screwdriver, tachometer (Echo P/N 99051130017) Parts required: None. NOTE Do not adjust carburetor unless necessary. If you have difficulty, see your ECHO dealer. - Page 23 Initial Adjustment 1. With engine off, turn HI speed screw (C) counterclockwise to stop. 2. Turn LO speed screw (B) midway between stops. 3. Turn idle screw (A) until tip of screw just touches throttle plate; then turn three (3) turns clockwise. Final Adjustment IMPORTANT Limiter caps prevent exceeding emission limits and over rich...
-
Page 24: Troubleshooting
ROUBLESHOOTING i l y s t r / d r t ' n t r a e r i l i f r e t l i f l r e t r o t y l r i l o r o t t ' n Fuel vapors are extremely flammable and may cause fire and/or explosion. -
Page 25: Storage
DANGER DANGER 7. Remove the spark plug and pour 7cc (1/4 oz.) of fresh, clean ECHO 2-stroke engine oil into the cylinder through the spark plug hole. A. Place a clean cloth over the spark plug hole. B. Pull the recoil starter handle 2-3 times to distribute the oil inside the engine. - Page 26 NOTES...
- Page 27 OWER LOWER PERATOR ANUAL NOTES...
-
Page 28: Servicing Information
• Sending a check or money order for $2.00 per Parts Catalog or $1.50 per Operator's Manual made payable to ECHO, INCORPORATED. State on a sheet of paper the model number and serial number of the ECHO unit you have, part number of the manual (if known), your name and address and mail to address below.