Echo GT-230 Operator's Manual

Hide thumbs Also See for GT-230:

Advertisement

Quick Links

x7722271404 / x772000164
Grass Trimmer
Operator's Manual
The muffler or catalytic muffler and surrounding cover may become extremely hot.
Always keep clear of exhaust and muffler area, otherwise serious personal injury may
occur.
The engine exhaust from this product contains chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
Users of this equipment risk injury to themselves and others if the unit is used
improperly and/or safety precautions are not followed. ECHO provides an operator's
manual and a safety manual. Both must be read and understood for proper and safe
operation. Failure to do so could result in serious injury.
Specifications, descriptions and illustrative material in this literature are as accurate as known at the time
of publication, but are subject to change without notice. Illustrations may include optional equipment and
accessories, and may not include all standard equipment.
X7702094204
© 04/2013 ECHO Inc.
GT-230
Burn Hazard

Advertisement

Table of Contents
loading

Summary of Contents for Echo GT-230

  • Page 1 Users of this equipment risk injury to themselves and others if the unit is used improperly and/or safety precautions are not followed. ECHO provides an operator’s manual and a safety manual. Both must be read and understood for proper and safe operation.
  • Page 2: Table Of Contents

    The Safety Manual........................3 Servicing Information ......................... 3 Parts/Serial Number........................3 Service ............................3 Echo Consumer Product Support ....................3 Warranty Registration ........................3 Additional or Replacement Manuals .................... 4 Safety..............................4 Manual Safety Symbols and Important Information ..............4 International Symbols ........................
  • Page 3: Introduction

    Service of this product during the warranty period must be performed by an Authorized ECHO Service Dealer. For the name and address of the Authorized ECHO Service Dealer nearest you, ask your retailer or call: 1-800-432-ECHO (3246). Dealer information is also available on our Web Site. When presenting your unit for Warranty service/repairs, proof of purchase is required.
  • Page 4: Additional Or Replacement Manuals

    ECHO Inc., 400 Oakwood Road, Lake Zurich, IL 60047 (800-673-1558). Always check the ECHO Web Site for updated information. Safety Videos are available from your Echo dealer. A $5.00 shipping charge will be required for each video. SAFETY...
  • Page 5: International Symbols

    Eye protection that meets ANSI Z87.1 or CE requirements must be worn whenever you operate the unit. Hand Protection Wear no-slip, heavy duty work gloves to improve your grip on the handles. Gloves also reduce the transmission of machine vibration to your hands. X7702094204 © 04/2013 ECHO Inc.
  • Page 6 ECHO does not recommend the use of ECHO products by anyone who has a pacemaker.
  • Page 7 Keep a Solid Stance • Maintain footing and balance at all times. Do not stand on slippery, uneven or unstable surfaces. Do not work in odd positions or on ladders. Do not over reach. X7702094204 © 04/2013 ECHO Inc.
  • Page 8: Equipment

    Equipment Use only ECHO approved attachments. Serious injury may result from the use of a non-approved attachment combination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and safety manual.
  • Page 9 The 50 or 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures are followed as listed in the Maintenance Section of this manual. X7702094204 © 04/2013 ECHO Inc.
  • Page 10: Description

    Locate the safety decal(s) on your unit. Make sure the decal(s) is legible and that you understand and follow the instructions on it. If a decal cannot be read, a new one can be ordered from your ECHO dealer. See PARTS ORDERING instructions for specific information.
  • Page 11 ) to close choke for cold start. Move choke lever to “Run” ( ) position to open choke. 17. AIR CLEANER - Contains replaceable filter element. 18. SPARK PLUG - Provides spark to ignite fuel mixture. X7702094204 © 04/2013 ECHO Inc.
  • Page 12: Contents

    The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions, shield installation and other assembly may be necessary. After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing parts.
  • Page 13: Assembly

    5 mm (3/16 in.) diameter locking tool (D). 3. Thread cutting attachment onto shaft clockwise until head is tight. Remember to remove the locking tooled. Semi-automatic nylon line heads must be used only with plastic debris shield with cut-off knife. X7702094204 © 04/2013 ECHO Inc.
  • Page 14: To Advance Trimmer Line

    1. Position front handle (E) in comfortable operating position and tighten wing nut (F). The cutting attachment should be 5-7.5 cm (2-3 in.) above the ground and as level as possible. X7702094204 © 04/2013 ECHO Inc.
  • Page 15: Operation

    Fuel Alternative fuels, such as E-15 (15% ethanol), E-85 (85% ethanol) or any fuels not meeting ECHO requirements are NOT approved for use in ECHO 2-stroke gasoline engines. Use of alternative fuels may cause performance problems, loss of power, overheating, fuel vapor lock, and unintended machine operation, including, but not limited to, improper clutch engagement.
  • Page 16 Stored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days, ninety (90) days when a fuel stabilizer is added. Stored two-stroke fuel may separate. ALWAYS shake fuel container thoroughly before each use. X7702094204 © 04/2013 ECHO Inc.
  • Page 17: Starting Cold Engine

    Note: If engine does not start with choke in “Run” position after 5 pulls, repeat instructions 2 - 5. 6. Throttle Trigger After engine warm-up, grip the rear handle and front handle. Depress the throttle trigger lockout, and gradually depress throttle trigger to increase engine RPM to operating speed. X7702094204 © 04/2013 ECHO Inc.
  • Page 18: Starting Warm Engine

    Move stop switch (A) to STOP position. If engine does not stop when stop switch is moved to STOP position, close choke - COLD START position - to stall engine. Have your ECHO dealer repair stop switch before using trimmer again.
  • Page 19: Maintenance

    If you are unsure or are not equipped with the necessary tools, you may want to take your unit to an ECHO Service Dealer for maintenance. To help you decide whether you want to DO-IT-YOURSELF or have the ECHO Dealer do it, each maintenance task has been graded.
  • Page 20: Air Filter

    When servicing model year 2012 and later equipment, only fuel supply hoses certified by EPA can be used to replace the original equipment supply hose. Fines up to $37,500 may be enforced for using an un-certified replacement part. X7702094204 © 04/2013 ECHO Inc.
  • Page 21: Spark Plug

    Removal of cooling passage blockages or cleaning of cooling fins is considered “Normal Maintenance.” Any failure attributed to lack of maintenance is not warranted. 1. Remove spark plug lead. X7702094204 © 04/2013 ECHO Inc.
  • Page 22: Exhaust System

    5. Clean carbon deposits from muffler components. Note: When cleaning carbon deposit, be careful not to damage the catalytic element inside muffler. 6. Replace screen if it is cracked, plugged, or has holes burned through. 7. Assemble components in reverse order. X7702094204 © 04/2013 ECHO Inc.
  • Page 23: Carburetor Adjustment

    This engine has been factory adjusted to maintain satisfactory starting, emission, and durability performance up to 1,100 feet above sea level (ASL) (96.0 kPa). To maintain proper engine operation and emission compliance above 1,100 feet ASL the carburetor may need to be adjusted by an authorized ECHO service dealer.
  • Page 24: Lubrication

    Note: Every unit is run at the factory and the carburetor is set in compliance with emission regulations. Carburetor adjustments, other than idle speed, must be performed by an authorized ECHO dealer. 1. Check idle speed and reset if necessary. If a tachometer is available, idle speed screw (A) should be set to the specifications found on “Specifications”...
  • Page 25: Nylon Line Replacement

    Trimmer head is now fully loaded and ready for operation. When the wear indicators located at the bottom of the Speed-Feed® head are worn smooth, or if holes appear, replacement of the cover or the entire Speed-Feed® head is required. Wear Indicators X7702094204 © 04/2013 ECHO Inc.
  • Page 26: Troubleshooting

    Fuel strainer clogged Clean or replace Fuel at carburetor No fuel at carburetor Fuel line clogged Clean or replace Carburetor See your Echo dealer No fuel at cylinder Carburetor See your Echo dealer Open choke Fuel at cylinder Clean/replace air filter...
  • Page 27: Storage

    Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there. 8. Install the spark plug (do not connect ignition cable). X7702094204 © 04/2013 ECHO Inc.
  • Page 28: Specifications

    Speed Feed® 400 Nylon line head, Line capacity 6 m (20 ft.) Handle Left - D-Loop, Right - Grip Shoulder Harness Optional P/N 99944200201 Idle Speed 3,000 RPM Clutch Engagement Speed 3,600 RPM Wide Open Throttle Speed (W.O.T.) 7,400 RPM X7702094204 © 04/2013 ECHO Inc.
  • Page 29: Warranty Statements

    PRODUCT SOLD IN USA AND CANADA BEGINNING 01/01/2010 ECHO'S RESPONSIBILITY THIS LIMITED WARRANTY IS ONLY APPLICABLE TO ECHO PRODUCTS SOLD BY AUTHORIZED ECHO DEALERS. IT IS EXTENDED TO THE ORIGINAL PURCHASER ONLY, AND IS NOT TRANSFERABLE TO SUBSEQUENT OWNERS EXCEPT FOR EMISSION RELATED PARTS. 1-800-432-ECHO.
  • Page 30 PURCHASED REPAIR PARTS, SHORT BLOCKS AND ACCESSORIES ATTENTION TWO-STROKE ENGINE POWER PRODUCT OWNERS (&+2 3RZHU %OHQGŒ 7ZR6WURNH 2LO THIS WARRANTY DOES NOT COVER DAMAGE CAUSED BY: PD[LPXP ® DISCLAIMER OF IMPLIED WARRANTIES MERCHANTABILITY 99922201032 11/18/2011 X7702094204 © 04/2013 ECHO Inc.
  • Page 31: Notes

    GT-230 NOTES NOTES X7702094204 © 04/2013 ECHO Inc.
  • Page 32 ECHO, INCORPORATED 400 Oakwood Road S85811001201/S85811999999 S85712009347/S85712999999 Lake Zurich, IL 60047 www.echo-usa.com...

Table of Contents