When The Engine Is Warm - Echo CS-370 Instruction Manual

Ignition switch
Start / Run
Push
Throttle lock button
Starter handle
Choke control knob
CS-370
Chain brake
Throttle trigger lockout
Throttle trigger
Lock Chain
brake
Open choke
WHEN THE ENGINE IS HARD TO
START
CAUTION
Make sure the bar and chain are free from any
obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock chain
brake before starting.
• Press throttle trigger lockout down while grasping
throttle trigger and push in throttle lock button.
• Move ignition switch to "RUN" position.
• Securely hold the chain saw as shown and pull
starter handle.
• when engine starts, immediately squeeze and then
release throttle trigger, to release throttle lock button.
CAUTION
• After starting the engine, immediately squeeze
and then release throttle trigger to release throttle
lock button, otherwise severe brake damage may
occur.
• Never use throttle lock button for cutting.
• Use the throttle lock button only in starting.
WARNING
• The chain will attempt to move when engine is
started with throttle lock button engaged.
• Do not start engine before chain brake is locked.

WHEN THE ENGINE IS WARM

CAUTION
Make sure the bar and chain are free from any
obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock chain
brake before starting.
• Confirm there is fuel and chain oil in the tanks.
• Move ignition switch to "RUN" position.
• Securely hold the chain saw as shown and pull
starter handle.
• Choke may be used if necessary, but after first firing
sound, squeeze throttle trigger to release choke and
return engine to idle.
NOTE
If engine does not start after 5 pulls, use cold start
procedure.
NOTE
Do not increase engine speed while chain brake is
locked. Severe brake damage will result.
18