Preparation For Use - Echo CS-370 Instruction Manual

(A)
(D)
(E)
(F)
Brake lever
(Front hand guard)
Brake connector
Clutch cover
Two nuts

PREPARATION FOR USE

(B)
(C)
13
WARNING
Saw chain is sharp! Always wear gloves when
handling assembly, otherwise serious personal
injury may result.
NOTE
The machine may be delivered with guide bar, tip
guard, and saw chain separated. Install guide bar, tip
guard, and saw chain as follows.
KICK GUARD TO BAR INSTRUC-
®
TIONS
Tools Needed: Two 11 mm (7/16 in.) wrenches.
For saws with Kick Guard
metrical Low-Kick type (Double Guard) guide bars.
1. Install bolt (A) in rear hole (B) of Kick Guard
through front hole (C) in guide bar.
2. IMPORTANT: Dimple (D) in Kick Guard
gage recess (E) in guide bar.
3. Tighten nut (F) and bolt (A) using 11 mm (7/16 in.)
wrenches until snug. Make certain Kick Guard
flush against guide bar.
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard
bar.
GUIDE BAR AND SAW CHAIN IN-
STALLATION/REMOVAL
NOTE
• Move the chain brake lever (Front Hand Guard) fully
rearward to remove or install the clutch cover to
chain saw.
• Align the brake connector of the clutch cover to the
groove on the side of the brake lever (Front Hand
Guard).
1. Remove air cleaner cover.
2. Remove spark plug lead.
3. Remove two clutch cover nuts and remove clutch
cover.
4. Remove bar and saw chain if necessary. See "Main-
tenance and Care" section for guide bar/saw chain
maintenance procedures.
P/N 2893201 and Sym-
®
and
®
must en-
®
®
is tight on guide
®
CS-370
is