Testing Your System; Allowing Computer Access To Your System - DSC Envoy NT9005 User Manual

Testing Your Test your system every week. Report any problems immediately to your installation
System company.
NOTE: Perform system tests during off-peak hours, such as early morning
or late evening.
1. If your system has remote monitoring, call the central station to tell them that
2. Begin with the system turned off. Press
3. To test each area of your system, open each door and window in turn, or walk
4. View the display to see all open zones.
5. If the system has any fire zones, activation will cause the alarm to sound in a
CAUTION: Do not use an open flame or burning materials to test a smoke
or heat detector. Contact your installer for information on safe methods of
testing detectors.
6. When you are finished testing the system, inform your central station. If the
NOTE: Some features described above will not be functional unless
enabled by your installer. Ask your installer which features are functional
on your system.
Allowing From time to time, your installer may need to send information to, or retrieve
Computer information from your security system. Your installer will call your system over the
Access to Your telephone line using a computer. You may need to prepare your system to receive
System this "downloading" call. To do this:
1. Press
For more information on this feature, ask your installer.
18
you are testing your system.
sounds the siren and turns on all keypad lights for two seconds. When the
sounder and keypad test is complete, press
in motion detector areas.
pulsed mode. To silence the alarm, press
system did not work properly, contact your installer.
[Master code]
6
depending on your installer's setup. During this time, the system will answer
incoming downloading calls.
[Master Code]
6
.
#
.
#
. This allows downloading for 1 or 6 hours
5
. The system
4