Rear Side Marker, Tail Lights, Turn Signals And Backup Lights - Replacement - Dodge DURANGO Owner's Manual

440 MAINTAINING YOUR VEHICLE
4. While firmly holding the headlight in your hands,
disconnect all connectors by following the procedure
described in Step 5 below.
5. Remove the bulb connector from the headlight, mak-
ing sure to pull and release the red tab on all connectors.
Loosen the connector by pressing down on the black
and/or green release which is located below or above the
red tab. The green release is located above the red tab on
the H13; the black release is located above the 3457AK
red tab.
6. Twist and remove socket from lamp.
7. Remove bulb from socket and replace.
NOTE: These are halogen bulbs. Take care not to touch
the bulb with your fingers. Body oils from your fingers
could cause excessive heat build-up which reduces bulb
life.
Rear Side Marker, Tail Lights, Turn Signals And
Backup Lights — Replacement
1. Remove the two push-pins from the tail light housing.