Maintenance - Dimplex DS5629 Service Manual

MAINTENANCE

WARNINg: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of fire,
electric shock or damage to persons.
Light Bulb Replacement
Allow at least 5 minutes for light bulbs to cool off before
touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark
section of the flame or when the clarity and detail of the log
exterior disappears. There are two bulbs under the log set
which generate the flames and embers.
Tool Requirements
Phillips screw driver
Helpful Hints
It is a good idea to replace all light bulbs at one time if they
are close to the end of their rated life. Group replacement
will reduce the number of times you need to open the unit
to replace light bulbs.
Upper Light Bulb Requirements
Quantity of 1 clear chandelier or candelabra bulbs with an
E-12 (small) socket base, 7 watt rating.
Upper Bulb Replacement
1. Open door by pulling the handle.
2. Locate the upper bulb bracket.
3. Bend light retainer bracket down.
4. Locate and remove the light bulb.
5. Insert new bulb.
6. Bend light retainer bracket back into its original posi-
tion.
7. Close the door.
Lower Light Bulb Requirements
Quantity of 2 clear chandelier or candelabra bulbs with an
E-12 (small) socket base, 60 watt rating.
Lower Bulb Replacement
1. Open door by pulling the handle.
2. Remove the screw from the logset located in the center
of the emberbed and remove the logset from the unit.
3. Locate and examine the bulbs to determine which
bulb(s) required replacement.
4. Locate and remove the light bulb(s).
5. Insert new bulb(s).
6. Install the logset into the unit, pushing firmly against
the glass. Replace the logset retaining screw into the
ember bed.
7. Close the door.
4
glass Cleaning
The clear door is cleaned in the factory during the as-
sembly operation. During shipment, installation, handling,
etc., the clear door may collect dust particles, these can be
removed by dusting lightly with a clean dry cloth.
To remove fingerprints or other marks, the clear door can
be cleaned with a damp cloth. The clear door should be
completely dried with a lint free cloth to prevent water
spots. To prevent scratching, do not use abrasive cleaners
or spray liquids on the clear door surface.
Plastic Door Cleaning
To remove fingerprints or other marks, the clear door can
be cleaned with a damp cloth. The clear door should be
completely dried with a lint free cloth to prevent water
spots. To prevent scratching, do not use abrasive cleaners
or spray liquids on the clear door surface.
Stove Surface Cleaning
Use warm water only to clean painted surfaces of the Com-
pact Stove. Do not use abrasive cleaners.
Servicing
Except for light bulb replacement and cleaning described
above, an authorized service representative should perform
any other servicing.
www.dimplex.com