Operation - Dimplex DS5629 Owner's Manual

Operation

Figure 1
To access the controls go to the
back of the Stove
A. 3-Position Switch
The switch has two on positions
marked with "-" and "=". The "-"
position is for manual operation.
In this position the built-in remote
control is bypassed. The "="
position is for operating the unit
with the provided remote control.
When in "=" position the unit is
operated with the on and off but-
tons of the remote control.
When the switch is in the center
position the unit is off.
B. Heater On/Off Switch
The Heater on/off Switch sup-
plies power to the heater fan and
the heater element.
C. Heater Thermostat Control
To adjust the temperature to your
individual requirements, turn the
8
thermostat control clockwise all
the way to turn on the heater.
When the room reached the
desired temperature, turn the
thermostat knob counter clock-
wise until you hear a click. Leave
in this position to maintain the
room temperature at this setting.
For additional heat, turn clockwise
until you hear the click again and
the heater will turn on. To turn the
heater off, switch the Heater on/
off switch to the off position.
!
NOTE: When the heater is
switched on, the heater fan will
operate. The heater element may
or may not be on, depending on
the thermostat control setting.
(See "Heater Thermostat Con-
trol")
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
heater off and it will not come
back on without being reset. It
can be reset by switching the on/
off Switch to off and waiting 5
minutes before switching the unit
back on.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call Dimplex
www.dimplex.com