Table of Contents
Advertisement
general Functions
LPC or the PCH and the controller
will need to be synchronized.
! NOTE: For ease of synchro-
nization it is suggested that the
controller be taken to each heater
to complete the synchronization
process.
1.
Press the
put the controller into syn-
chronization mode.
2.
all four (4) zone icons will
begin to flash.
3.
select the zone that the spe-
cific heater will be associated
with, that icon will become
solid.
4.
on the heater press and hold
the V button for 3 seconds,
both the
begin to flash.
5.
Press the
on the heater.
6.
Within 10 seconds press the
icon on the controller.
! NOTE: When the synchroniza-
tion is complete the display on
the heater will switch to the new
settings from the controller.
7.
Repeat steps 3-5 until all of
the heaters are synchronized.
8.
Press the
back to operation mode.
14
icon, this will
and
icons will
– , ✚ and then V,
icon to revert
5. Lock Function
The controller can be "Locked"
so that the display on the control-
ler are disabled to prevent any
changes to the settings in the
system.
To Enable:
1.
Press the
2.
Enter the sequence Zone 1,
Zone 2, Zone 3 and Zone 4,
then press the
The Controller will display the
Icon and continue to operate
based on the settings and signals
from the controller.
! NOTE: adjustments can
be made to individual heaters
by entering it's specific unlock
sequence and adjusting the set
point.
CAUTION: The adjusted
heater will only retain the new set
point until an event occurs on the
controller and a new set point is
sent.
To Disable:
1.
Press and hold the
3 seconds.
2.
Enter the sequence Zone 1,
Zone 2, Zone 3 and Zone 4,
then press the
Icon.
Icon.
Icon for
Icon.
www.dimplex.com
Hide quick links:
Advertisement
Table of Contents
