Vivotek IP8335H User Manual page 9

Assembling Steps
1. Disassemble the components of the waterproof connector into part (A) ~ (F) as shown above.
2� Remove the rubber stopper from the bottom of the Network Camera and secure the rubber (A)
and screw nut (B) tightly�
3� Open the back cover of the Network Camera�
4� If you have external devices such as sensors and alarms, feed the cables through the
waterproof connector (F --> E --> C --> A+B) as the illustration shown below. Then refer to
the pin definition to connect them to the general I/O terminal block. Note: The recommended
cable gauge is 2�0 ~ 2�8 mm�
5� Push the seal (C) into the housing (E)�
6� Insert the seals (D) into the empty holes on the seal (C) to avoid moisture�
7. Secure the sealing nut (F) tightly.
8� Tighten the back cover�
9� Remove rubber (G) and feed the cables through the wall mount bracket�
(C)
5
2
3
(A)+(B)
(C)
(E)
(F)
(E)
(F)
4
6
(C)
(D)
VIVOTEK
(F)
7
8
(G)
9
User's Manual - 9