Ptz - Vivotek IP8172 User Manual

VIVOTEK
NOTE:
NOTE
► The Preset Positions will also be displayed on the home page. Select one from the Go to drop-down
list, and the Network Camera will move to the selected preset position.
► Click Patrol: The Network Camera will patrol along the selected positions repeatedly.

PTZ

Mechanical PTZ Operation
If you select "Mechanical", the RS485 Settings section will be displayed as shown below:
RS485 Settings
Disable: Select this option to disable this function.
PTZ camera: Select this option to enable PTZ operation.
To utilize this feature, please connect the Network Camera to a PTZ driver or scanner via RS485 serial
interface first. Then you can configure the PTZ driver and RS485 port with the following settings.
VIVOTEK provides five PTZ drivers: DynaDome/SmartDOME, Lilin PIH-7x00, Pelco D, Pelco P, and
Samsung Scc643 protocol. If none of the above PTZ drivers is supported by your PTZ scanner, please
select Custom camera (scanner). Please refer to the documentation of your PTZ scanner to determine
the Camera ID, PTZ driver, and Port settings. The Camera ID is necessary to control multiple cameras.
If you click Save to enable this function, the camera control panel will be displayed on the main page.
Please refer to the illustration on page 80.
96 - User's Manual