Table of Contents
Advertisement
Above roof installation — PV modules horizontal
3.
1.
9
4
Fitting mounting rails
Number and distribution of the supports
2 modules
A Support
Note
Supports are not required on roofs with
corrugated cover or on sheet steel
roofs.
2.
Trim approx. 30 mm from tile.
3 modules
■ Install supports above an existing roof
batten or a timber.
■ Undo the screws on the supports.
Push the supports onto the bottom of
the mounting rails then, using gentle
pressure, position on the roof cover
and tighten screws.
(cont.)
4 modules
27
Advertisement
Table of Contents
