Further Adjustments Switching Times For The Heating Water Buffer Cylinder - Viessmann VITOCAL 300-A Operating Instructions Manual

Further adjustments
Switching times for the heating water buffer cylinder
■ At the factory, "STANDARD" is set for
every day from 0:00 to 24:00 h, i.e. all
rooms are heated all day to the stand-
ard room temperature.
■ For the heating water buffer cylinder,
setting the switching times effects a
changeover between operating
modes "FIXED VALUE", "STAND-
ARD", "REDUCED", and "OFF".
Note
■ In "FIXED VALUE" mode, the heating
water buffer cylinder is heated to a
fixed default temperature (50 °C in the
delivered condition). You can utilise
this operating mode, for example to
heat up the heating water buffer cylin-
der with economical night tariff power.
The "FIXED VALUE" temperature is
set by your heating contractor.
■ In "STANDARD" mode, the heating
water buffer cylinder is heated to the
flow temperature selected for the heat-
ing circuit.
The heating circuit flow temperature is
set by your heating contractor.
■ In "REDUCED" mode, a smaller vol-
ume of heating water is available than
in "STANDARD" mode.
Switch t buffer cyl.
0 3 6 9 12 15 18 21 24
20:00-20:14
MONDAY
TUESDAY
WEDNESDAY
THURSDAY
FRIDAY
SATURDAY
SUNDAY
STANDARD
>>
DAY VALUE SET>>
36
■ You can set switching times individu-
ally for the following days or parts of
the week:
– The same for every day: Monday to
Sunday
– For individual parts of the week:
Monday to Friday, Saturday to Sun-
day, Monday to Saturday
– For every day individually: Monday,
Tuesday, etc.
3
3
3
3
3
3
3
2: REDUCED
1: OFF
OK
4: FIXED VALUE
3: STANDARD