Toshiba e-studio162 Operator's Manual page 72

TROUBLESHOOTING AND MAINTENANCE
Lamp indicator
Blinks
Error
indicator
Steadily
lit
MEMORY FULL, PRESS START TO
RESUME.
NO 2-SIDED COPY FROM BYPASS
TRAY.
NO 2IN1 COPY FROM
BYPASS TRAY.
NO 2IN1 COPY WITH MARGIN SHIFT. 2 IN 1 copy and margin shift cannot be
COPY RATIO CAN NOT BE
CHANGED IN 2IN1.
THIS MENU IS NOT SELECTABLE
WITH DATA.
NO XXXX SIZE TRAY
CHECK ADF/RADF.
START TO RESUME.
LOAD XXXX PAPER INTO TRAY<*>.
NO PC COMMUNICATION; CHECK
CABLE.
70
Indication
Display
INSTALL A
TONER
CARTRIDGE.
TONER
CARTRIDGE IS
NEAR EMPTY.
MAINTENANCE
REQUIRED CALL
FOR SERVICE
Cause and remedy
The toner cartridge is not installed
correctly. Reinstall the toner cartridge.
Replacement of toner cartridge will be
needed soon. Prepare a new cartridge.
Service by an authorized service
technician is required.
Data is being held in memory. Print the
data or clear it from memory.
Two sided printing or 2 IN 1 copying is
selected when the bypass tray is
already selected, or the bypass tray is
selected when two-sided printing or 2
IN 1 copying is already selected.
The bypass tray cannot be used. Press
the [TRAY SELECT] key (
a paper tray.
used in combination.
Copy ratio can not be changed in 2 IN 1
copy.
This appears if you attempt to change
a user program setting while a print job
is in progress.
There is no paper for printing. Press
the [MODE SELECT] key to switch to
printer mode and follow the instructions
in the display.
("XXXX" indicates paper size)
An original remains on the document
glass, or the original is too thick to
scan. Remove the original.
If the message is not cleared when
there is no original on the document
glass, the underside of the ADF/RADF
is dirty. Clean the underside of the
ADF/RADF. (especially areas where
black lines appear.)
Printing is not possible if the paper size
setting is different from the size of
paper loaded in the tray. Load the
same size of paper as the paper size
setting and then press the [START] key
( ). Printing will begin.
("XXXX" indicates paper size. The tray
is indicated in <*>.)
The machine is not correctly connected
to the computer. Check the cable
(when using the scanner function).
Page
83
83
-
30
26
31
) to select
31
34
25
31
62
-
21
88
15
55