Step 2G: Create Dial 0 Destination; Step 2H: Direct Co Lines To Ring Ctx Attendant Console - Toshiba STRATA CTX Installation Manual

Attendant console

Hide thumbs Also See for STRATA CTX:

Table of Contents

Installation

Step 2: Program CTX for the Console

3. If the CTX telephone system is networked, use Program 656 to assign the network node. If the

CTX is not networked to another telephone system, skip this program.

Step 2G: Create Dial 0 Destination

Enter Program 102, then enter data for the FB listed below:

The number entered here (usually 0), is the number users dial to reach an Attendant.

Note

Important!

Refer to the Strata CTX Programming Manual for details. The Attendant dialing digit is "0."

FB01 – Assign a unique node number for your CTX. Enter zero for the Primary Overlap

Code.

FB00 – In CTX WinAdmin, click the Create button to assign Attendant Console Group

DN. In the pop-up window, enter an Index value of 0 (zero), click OK. Most sites will use

0; however; any non-conflicting DN can be used.

...or for telephone programming, at the "Digit=" prompt, enter 0 (or any DN that does not

conflict with a station DN). At the "FB0=" prompt, enter

Do not assign a PDKU or BDKU port as DN = 0.

Strata CTX Attendant Console Installation 03/03

Table of Contents