Step 2C: Make Dkt Data Assignments On Ctx; Step 2D: Dkt Button Assignments - Toshiba STRATA CTX Installation Manual

Step 2C: Make DKT Data Assignments on CTX

1. Enter Program 204, enter the Prime DN for this particular Attendant Console.
2. Enter data for the FBs listed below:
FB01 – Press
FB02 – Press
FB05 – Press
FB19 – Press
FB21 – Press
FB30 – Press
Notes
• FB19 and FB30 settings can be changed within the CTX Attendant Console application (see
Administration view, Admin tab in the console). These two settings can be changed in CTX
programming or from the CTX Attendant Console. The console has precedence; the console
overrides programming data.
• Although FB28 is labeled "Attd Overflow Dest.," you should enter the overflow destination
from Program 404.

Step 2D: DKT Button Assignments

Do not make any button assignments in Program 205 for the Attendant Console port. In the
previous step, Program 204, FB02, Pattern 3 (key strip assignment) enables the correct
assignments for the port (whether the console is connected to a BATI or DKT).
No other telephones in the system should have an appearance of the Console's PDN.
Note
Strata CTX Attendant Console Installation 03/03
Enter CTX Station DN
to assign the Station Type as "Attendant" (required).

to assign the key strip assignments for the Attendant Console (required).

to assign Tone First signaling (required).

(Not Continuous) to disable continuous DTMF.

to select the "BATI" adapter type (required).

to disable Automatic Line Hold.

Step 2: Program CTX for the Console
Required
Installation
Required
6441
5