Output Status Display - Fostex FM-3 Owner's Manual

<Memo>: If you switch the microphone power
supply switch of INPUT 1 to "T12", the input sta-
tus display changes as below.
If you set the microphone power supply switch of
INPUT 1 to "T12" and set the microphone power
supply switches of INPUT 2 and INPUT 3 to "P48",
the input status display looks as follows.
(3) Press the [EDIT] key to exit the status display
mode.
The display changes to the meter display.
<Note>: If you need to supply the T12 power, set
the T12 power supply function to "ENA" by the
similar procedure as above.
<Memo>: The T12 disabled/enabled setting re-
mains even after you turn off the unit. However, if
you initialize the flash memory using the system
status display, it is reset to the default setting (En-
abled).

Output status display

On the output status display, not only you can see the
current status of the following switches, but also you
can set the threshold and ratio of the limiter. The follow-
ing shows the default setting when the unit is shipped.
Front panel
Right side panel
The following icons are shown according to the switch setting.
• [LIMITER] switch status
When the [LIMITER] switch is set to "OFF", the param-
eter boxes for the threshold and ratio show "
When the [LIMITER] switch is set to "ON" or "LINK", the
parameter boxes for the threshold and ratio show the
current parameter values.
You can edit the parameter values by following the pro-
cedure described in the next page.
Switch
setting
Icon
THRE
RATIO
• AUX OUT switch status
Switch
OFF
setting
Icon
• AUX OUT level switch
Switch
setting
Icon
• SUB OUT level switch
• MAIN OUT (L, R) level switches
Switch
setting
Icon
17
Right side panel
Right side panel
OFF
ON
1/2 2/3 1/3
-10
+4
0 -20
".
LINK
L/R L+R
-60
-60