Fostex DV40 Operation Manual page 37

4. ETHERNET port
• Connects to an Ethernet network.
ETHERNET
• Connector: IEEE802.3, conformed
to 10BASE-T/100BASE-T
• LED indicators
* 10/100: When the connection to
a network is established by
10/100
100BASE-TX, this indicator is lit.
LINK
(It is not lit when the connection
TX/RX
is established by 10BASE-T.)
* LINK: When the unit recognizes the
network, this indicator is lit.
* TX/RX: When data is transmitted
or/and received, this indicator is
lit.
5. Digital input/output section
A
DIGITAL INPUT
TR4-3 TR2-1
TR2 TR1
DIGITAL OUTPUT
TR4-3 TR2-1
TR2 TR1
1:GND
TR1 192kHz
2:HOT
176.4kHz
3:COLD TR2
B
A. DIGITAL INPUT connectors
• Each connector accepts a digital signal conformed
to the IEC 60958 (AES/EBU) or IEC 60958 (S/P
DIF) format. The unit can automatically detect the
format.
• Connectors: XLR-3-31 type
B. DIGITAL OUTPUT connectors
• Each connector outputs a digital signal conformed
to the IEC 60958 (AES/EBU) or IEC 60958 (S/P
DIF) format. The format is selected in the Setup
mode.
• Connectors: XLR-3-32 type
6. Video clock section
INPUT
ON OFF
A
A. VIDEO INPUT connector
• Accepts a video clock signal.
• Connector: BNC type
B. 75 (ON/OFF) switch
• To terminates the video clock, set this switch to
ON.
C. VIDEO THRU connector
• Echoes an incoming video signal.
• Connector: BNC type
2 1
3
1
2
3
VIDEO
THRU
75
B C
7. Cooling fan motor speed select switch
Switches the cooling fan motor speed between LOW
and HI. Setting it to LOW lowers the motor noise.
8. AC IN connector
Connect the supplied power cord.
9. Word clock section
A
A. WORD INPUT connector
• Accepts a word clock signal.
• Connector: BNC type
B. 75 (ON/OFF) switch
• To terminates the word clock, set this switch to
ON.
C. WORD THRU connector
• Echoes an incoming word clock signal.
• Connector: BNC type
D. WORD OUTPUT connector
• Outputs a word clock signal from the unit.
• Connector: BNC type
10. GPI input/output connectors
These connectors are active only when the "GPI ON/
OFF" menu in the Setup mode is set to "On". It is set
to "Off" in the initial setting, therefore, you have to
change it to "On" before using the GPI connectors.
GPI
INPUT
A
A. GPI INPUT connector
• Connector: DIN-5 pin
• The following table shows the pin assignment.
A TTL-level, low active input signal activates the
operation.
Pin-1 GND
The low plus signal activates the operation
Pin-2 STOP
equivalent to the STOP key operation.
The low pulse signal activates the operation
Pin-3 PLAY
equivalent to the PLAY key operation.
The low pulse signal activates the operation
Pin-4 >>
equivalent to the SKIP >> key operation.
The low pulse signal activates the operation
Pin-5 <<
equivalent to the SKIP << key operation.
* The minimum input pulse width is 15 msec (except for Pin 2
PLAY, whose minimum input pulse width is 5 msec).
2-15
WORD
INPUT THRU OUTPUT
75
ON OFF
D
B C
OUTPUT
5
4
2
3
B
1