Heated Blanket And Mattress Pad; Set Up - Sunbeam Sleep warm. Sleep well. User Manual

BED6322 BeddingMan06-Just English.qxd
Heated Blanket and Mattress Pad Set Up
1 Place the heated blanket/mattress pad on the bed with the label at the foot
of the bed facing upward.
2 Connect the cord into the module at the bottom of the heated blanket/
mattress pad until the plastic hinges click into place.
CAUTION: Cord must be COMPLETELY CONNECTED. A risk of fire could
result from a loose connection.
3 Run the control cord on the floor under the bed. Do not sandwich cord
between the mattress and box spring. Avoid any tangling or pinching.
4 Control Placement:
• Dual Control for heated blanket or mattress pad –
place primary control (label on back of control)
on the right side of the bed.
• Single Control for heated blanket or mattress pad –
the control can be placed on either side of the bed.
Blanket Cord Connector
5 Plug power cord into a 110-120 volt wall outlet.
IMPORTANT
CAUTION: Do not plug main power cord into the wall outlet until you have completely
set up your heated product per the instructions.
• Disconnect power cord from wall before detaching control from heated product.
• Always make sure cords are NOT trapped or pinched between bed slats, mattress,
CAUTION: Do not attempt to force the plug. This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electrical shock, this plug is intended to fit only one way into an outlet. If the
plug does not fit in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Secondary
Control
2
Mattress Pad
Cord Connector
run cord
under the bed
3
Flag Tag
Left Side
Module 1
2
Label
Flag Tag
run cord
under the bed
springs, against wall, foot board or bed frame, or between furniture, walls or chairs.
For questions or support, please visit: www.sunbeam.com
3/8/06 12:18 PM
Left Side
Right Side
Module
1
Label
Right Side
See Control Features on page 4
for your individual control.
3
Page 7
2
Power
5
Cord
Primary
Control
(Label on back
of control)
5
Power
Cord
4
Primary
Control
(Label on back
of control)
If there is a flashing light or
your control displays a flashing
"FF", see page 8.
4
3