Sunbeam SHWL825 Series User Manual

Heated Shawl/Throw
Models: SHWL825XX
IMPORTANT SAFETY INSTRUCTIONS
DO NOT DESTROY
WARNINGS AND SAFEGUARDS
AS WITH ALL ELECTRICAL PRODUCTS, MISUSE OF PRODUCT OR FAILURE TO PROPERLY
FOLLOW THE INSTRUCTIONS MAY CAUSE OVERHEATING, FIRE OR PERSONAL INJURY.
PLEASE READ THE PRODUCT LABEL AND ALL OF THE INSTRUCTIONS BEFORE USING YOUR
HEATED PRODUCT.
1. DO NOT USE THIS HEATED PRODUCT WITH AN INFANT, A CHILD, AN
INCAPACITATED OR IMMOBILE PERSON, A PARAPLEGIC, A QUADRIPLEGIC,
A DIABETIC, ONE INSENSITIVE TO HEAT SUCH AS A PERSON WITH POOR
BLOOD CIRCULATION, OR ANYONE WHO CANNOT CLEARLY UNDERSTAND
THE INSTRUCTIONS AND/OR OPERATE THE CONTROLS.
2. DO NOT USE WITH DAMAGED CORDS. DAMAGED CORDS CAN LEAD TO FIRE. DO
NOT TUCK IN, TRAP, FOLD, CROSS OR PINCH CORDS OR CONTROLS BETWEEN BED
SLATS, MATTRESS OR SPRINGS, OR AGAINST WALLS, FOOTBOARDS OR BED FRAME.
3. DO NOT DRY CLEAN THIS HEATED PRODUCT. CLEANING LIQUID MAY DAMAGE
THE INSULATION OF THE HEATING ELEMENT. IMPROPER LAUNDERING MAY
CAUSE PROBLEMS WITH THE HEATING WIRE WHICH CAN LEAD TO FIRE.
4. DO NOT TUCK IN, PINCH, FLEX OR EXPOSE THE HEATING WIRE TO RUBBING.
A DAMAGED HEATING WIRE MAY RESULT IN POSSIBLE OVERHEATING OR
FIRE. DO NOT TUCK OR WRAP THE HEATED PRODUCT, SUPPLY CORD OR
CONTROL IN A SOFA OR OTHER FURNITURE. ALL PORTIONS OF THE HEATED
PRODUCT AND CONTROLLER SHOULD BE VISIBLE AT ALL TIMES.
5. TURN OFF OR UNPLUG THE CONTROL FOR THE HEATED PRODUCT WHEN NOT USING.
6. WRAPPING THE CORD AROUND THE CONTROLLER MAY
DAMAGE THE CORD. LOOP LOOSELY WHEN STORING.
7. CONTROLLER IS NOT WATERPROOF. DO NOT IMMERSE IN WATER.
8. KEEP THE CONTROL AWAY FROM DRAFTY AREAS THAT MAY
BECOME DAMP OR WET SUCH AS AN OPEN WINDOW.
9. DO NOT USE PINS; THEY MAY DAMAGE THE ELECTRIC WIRING.
10. BE SURE THIS THROW IS USED ONLY ON AN AC SUPPLY CURRENT CIRCUIT
OF 110-120 VOLTS. DO NOT USE WITH AN EXTENSION CORD.
11. THE PRODUCT MAY EXPERIENCE INCREASED HEAT IN AREAS WHERE
HEATED PRODUCT IS BUNCHED OR FOLDED WHILE IN USE.
12. KEEP ALL DOGS, CATS AND OTHER PETS AWAY FROM THIS
HEATED PRODUCT. THIS IS AN ELECTRICAL APPLIANCE
THAT THEY CAN DAMAGE OR BE INJURED BY.
13. DO NOT USE WITH ROCKING CHAIRS, RECLINERS, CHAIRS WITH
CASTERS OR WHEELS, OR OTHER FURNITURE SUBJECT TO
MOVEMENT. DO NOT WRAP PRODUCT AROUND CONTROL.
14. DO NOT USE ANOTHER ELECTRONIC HEATING DEVICE IN
CONJUNCTION WITH YOUR HEATED PRODUCT.
15. IF THE FOLLOWING IMPORTANT INSTRUCTIONS ARE NOT FOLLOWED,
THE HEATED PRODUCT WILL NOT OPERATE PROPERLY.
16. NOT FOR HOTEL, MOTEL OR OTHER INSTITUTIONAL USE.
17. IF YOU SEE THE HEATED PRODUCT OPERATING IMPROPERLY,
UNPLUG IT IMMEDIATELY AND CALL SUNBEAM CONSUMER CARE
IN THE U.S AT 800-892-7684 OR IN CANADA AT 800-667-8623.
18. DO NOT TUCK IN WIRED AREA OF BLANKET OR THROW.
19. DO NOT USE WITH GENERATOR POWER.
THIS APPLIANCE HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER). TO REDUCE THE RISK
OF ELECTRIC SHOCK, THIS PLUG IS INTENDED TO FIT IN A POLARIZED OUTLET ONLY ONE WAY. IF THE PLUG
DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE PLUG. IF IT STILL DOES NOT FIT, CONTACT A QUALIFIED
ELECTRICIAN TO INSTALL THE PROPER OUTLET.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS SAFETY
FEATURE IN ANY WAY.
Personal Heated Throw_13EFM1.indd 1
HOW TO USE YOUR SUNBEAM HEATED SHAWL/THROW
®
Make sure Control Connector is securely connected to the Throw Connector (Figure 1). Push both parts together
for a tight fit. NOTE: The connectors are keyed to only fit one way; align arrow.
1. Plug into any 120V AC electrical outlet.
2. To turn on, press the Power Button. Shawl/throw will NOT turn on
until you press the Power Button. NOTE: If the heat level indicators
do not light up or stay on, the plug or Control Connector may not
be firmly and completely connected. Unplug from wall outlet,
check the Throw connection again and re-plug into outlet.
3. Select from 4 heat settings by pressing Push-Button successively to
achieve desired heat level. To turn OFF, you must scroll through the
remaining heat settings by pressing the Power Button sequentially.
4. Allow your shawl/throw to preheat for several minutes.
Your shawl/throw has been designed to meet the
maximum heat output according to UL Standards.
NOTE: A red blinking "High" light indicates an error has occurred. Unplug
from outlet, verify physical condition of cord, function of AC outlet and proper
connection between connector and throw/shawl. If blinking light persists, discontinue use and contact Consumer
Services.
AUTO-OFF FEATURE
Your controller includes an Auto-Off feature. This feature is designed to conserve energy by automatically turning
off after 3 hours of continuous use. The red Auto-Off light will blink, indicating that this feature has activated.
NOTE: After a power outage, the Auto-Off feature automatically resets the timer.
CARE AND CLEANING OF YOUR PRODUCT
We recommend washing before initial use. DO NOT BLEACH.
Before Washing or Storing Your Heated Shawl/Throw:
1. Disconnect power cord from wall BEFORE detaching control cord from the heated product.
2. Ensure that no cords are still connected and none of the wires have worn through the fabric.
3. Carefully follow all washing instructions or your heated product may shrink and possibly cause a fire hazard.
• DO NOT submerge control in water.
• DO NOT dry clean your heated product. Dry cleaning solvents may damage the wires.
• DO NOT use bleach or cleaning fluids.
• DO NOT use a wringer.
• DO NOT iron your heated product.
• DO NOT use mothballs or sprays of any kind.
• DO NOT reconnect the heated product or use it until it is COMPLETELY dry.
• DO NOT wash or put into water the power cord or any of the product's cords.
• DO NOT use analgesic cream in combination with your heated product.
Taking care of your heated product is easy and safe as long as you follow a few simple steps.
Machine Washing
1. Presoak the shawl/throw for 15 minutes in mild soap and cold water.
2. Wash in mild soap and cold water on the "delicate" or "gentle" cycle in
the washer for two minutes. Remember, do not use bleach.
3. Rinse in fresh, cold water.
4. Spin dry in the washing machine. Then gently stretch to its original size.
Machine Drying
CAUTION: Do not use commercial dryers or the dryers at your local laundromat.They get
too hot and would damage the wiring of the heated product.
1. Preheat the dryer on the "low" temperature setting for 2 minutes.
2. Place throw/shawl into the dryer and tumble dry for 10 minutes at a low temperature.
3. Remove the throw/shawl while it is still damp and gently stretch it to its original size.
4. Drape the heated product over a clothesline or a shower rod. DO NOT use clothespins.
5. Heated product must be COMPLETELY dry before reconnecting the power plug or control plug.
Hand Drying
1. Gently stretch the shawl/throw back to its original size.
2. Drape the heated product over a clothesline or hang over a shower rod. DO NOT use clothespins.
3. Heated product must be COMPLETELY dry before reconnecting the power plug or control plug.
DO NOT RETURN THIS PRODUCT TO THE PLACE OF PURCHASE.
If you have any questions while setting up or using your product, please visit us on the World Wide Web at:
www.sunbeambedding.com or contact Sunbeam Consumer Care in the U.S. at (800) 892-7684
or in Canada at (800) 667-8623.
LIMITED WARRANTY
Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada) Limited
doing business as Jarden Consumer Solutions (collectively "JCS") warrants that for a period stated below from the date of
purchase, this product will be free from defects in material and workmanship.
• All heated products branded "Sunbeam ® " and "SlumberRest
JCS, at its option, will repair or replace this product or any component of the product found to be defective during the warranty
period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available,
replacement may be made with a similar product of equal or greater value.
This is your exclusive warranty. Do NOT attempt to repair or adjust any electrical or mechanical functions on this product.
Doing so will void this warranty.
This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Keep the
original sales receipt. Proof of purchase is required to obtain warranty performance. JCS dealers, service centers, or retail
stores selling JCS products do not have the right to alter, modify or any way change the terms and conditions of this warranty.
This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or misuse of
the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair or alteration
by anyone other than JCS or an authorized JCS service center. Further, the warranty does not cover: Acts of God, such as fire,
flood, hurricanes and tornadoes.
What are the limits on JCS's Liability?
JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory
warranty or condition.
Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular
purpose is limited in duration to the duration of the above warranty.
JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise.
JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product
including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or
otherwise, or for any claim brought against purchaser by any other party.
Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or
limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights that vary from province to province, state to
state or jurisdiction to jurisdiction.
How to Obtain Warranty Service
In the U.S.A. - If you have any question regarding your heated product, this warranty or would like to obtain warranty service, please
visit our web site at: www.sunbeam.ca or contact Jarden Consumer Care at 1 800 892-7684 and a convenient service center address
will be provided to you.
In Canada - If you have any question regarding your heated product, this warranty or would like to obtain warranty service, please visit
our web site at: www.sunbeam.ca or contact Jarden Consumer Care at: 1 800 667-8623 and a convenient service center address will
be provided to you.
In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions located in Boca
Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing business as Jarden
Consumer Solutions, located at 20B Hereford Street, Brampton, Ontario L6Y 0M1. If you have any other problem or claim in
connection with this product, please contact our Consumer Service Department.
PLEASE DO NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE.
© 2013 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Imported and distributed by
Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, 20 B Hereford Street, Brampton, Ontario
L6Y 0M1.
Printed in China. GCDS-SUN30530-JC
www.sunbeam.ca
1. Control Connector
2. Throw Connector
3. Locking Clips
4. Alignment Arrows
® " will carry a FIVE year limited warranty.
PN: 171520
7/10/13 8:24 AM