Blade Assembly - Sunbeam PB9800 Instruction/Recipe Booklet

Blade Assembly

Important: Always ensure the blender is
unplugged from the power outlet before
fitting or removing the blade assembly.
Always handle the blade assembly with
caution, as the blades are extremely sharp.
➀
➁
Figure 2
To assemble the blade assembly, follow these
steps and refer to Figure 2;
1.Ensure the flat sides of the blade assembly
are aligned with the corresponding flat
sides of the opening in the bottom of the
jug (refer to Figure 3). Once the blade is
aligned, push the blade assembly firmly
into the opening.
Ensure the assembly is pushed all the way
to seat the seal.
2.Place the locking nut on the underside
of the jug and tighten by rotating in a
clockwise direction.
Figure 3
11