Configuring The Fortigate Unit For Snmp Monitoring; Configuring Fortigate Snmp Support - Fortinet FortiGate FortiGate-800 Installation And Configuration Manual

Fortinet network device installation and configuration guide
Hide thumbs Also See for FortiGate FortiGate-800:
Table of Contents

Advertisement

Configuring SNMP

Configuring the FortiGate unit for SNMP monitoring

Configuring FortiGate SNMP support

174
RFC support includes support for most of RFC 2665 (Ethernet-like MIB) and most of
RFC 1213 (MIB II) (for more information, see
This section describes:
Configuring the FortiGate unit for SNMP monitoring
Configuring FortiGate SNMP support
FortiGate MIBs
FortiGate traps
Fortinet MIB fields
Before a remote SNMP manager can connect to the FortiGate agent, you must
configure one or more FortiGate interfaces to accept SNMP connections. See
"Controlling administrative access to an interface" on page
Use the information in this section to configure the FortiGate unit so that an SNMP
manager can connect to the FortiGate SNMP agent to receive management
information and traps.
Configuring SNMP access to an interface
Configuring SNMP community settings
Configuring SNMP access to an interface
Before a remote SNMP manager can connect to the FortiGate agent, you must
configure one or more FortiGate interface's to accept SNMP connections. The
configuration steps to follow depend on whether the FortiGate unit is operating in
NAT/Route mode or Transparent mode.
To configure SNMP access to an interface in NAT/Route mode
1
Go to System > Network > Interface.
2
Choose the interface that the SNMP manager connects to and select Modify
3
For Administrative Access select SNMP.
4
Select OK.
To configure SNMP access to an interface in Transparent mode
1
Go to System > Network > Management.
2
Choose the interface that the SNMP manager connects to and select SNMP.
Select Apply.
Configuring SNMP community settings
You can configure a single SNMP community for each FortiGate device. An SNMP
community consists of identifying information about the FortiGate unit, your SNMP get
community and trap community strings, and the IP addresses of up to three SNMP
managers that can receive traps sent by the FortiGate SNMP agent.
System configuration
FortiGate
MIBs).
143.
.
Fortinet Inc.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents