Advertisement
TN2.600D Wire Connections
1.
Speaker Connection Terminal
Connect speaker(s) with a minimum impedance of 2Ω to the
corresponding (+) & (-) terminals.
If one subwoofer with 4Ω is used, bridge the amplifier using
the (R+) & (L-) terminal. If two subwoofers are used with 2Ω
each, use one (+) & (-) terminal for each subwoofer.
2.
Fuses
The fuses protect the amplifier from internal electrical damage
if overloaded. In the event they fail, replace with similar type
and amperage value. Using a higher amperage value may lead
to electrical damage and is not considered covered by the
limited warranty.
TN2.600D Wire Connections End Panel
3.
Power Connection Terminal
GND Connect good quality 8ga. ground wire to the nearest
vehicle chassis ground. Take a moment to properly prepare the
ground location for the best ground.
REM Connect the remote turn-on output of the source unit to
the remote terminal.
+12V Connect good quality 8ga. power wire to the vehicle's
battery. Always protect the vehicle by using a fuse within 18"
from the battery.
Advertisement
