Adding Dns Server Ip Addresses; Configuring Routing - Fortinet FortiGate 100 Installation & Configuration Manual

Network configuration

Adding DNS server IP addresses

Configuring routing

FortiGate-100 Installation and Configuration Guide
Figure 2: Configuring the management interface
Several FortiGate functions, including sending email alerts and URL blocking, use
DNS.
To set the DNS server addresses:
1 Go to System > Network > DNS.
2 Change the primary and secondary DNS server addresses as required.
3 Select Apply to save your changes.
This section describes how to configure FortiGate routing. You can configure routing
to add static routes from the FortiGate unit to local routers. Using policy routing you
can increase the flexibility of FortiGate routing to support more advanced routing
functions.
You can also use routing to create a multiple Internet connection configuration that
supports redundancy and load sharing between the two Internet connections.
This section describes:
• Adding a default route
• Adding destination-based routes to the routing table
• Adding routes in Transparent mode
• Configuring the routing table
• Policy routing
Configuring the management interface (Transparent mode)
115