Adding A Pri Gateway (Auto-Discovered) - Fortinet FortiVoice Gateway GT01 Deployment Manual

Pri gateway

Hide thumbs

Table Of Contents

Table of Contents

Deployment

g. If the build number of the firmware version running on the gateway matches the one on the Fortinet Support

website, then you do not need to perform an upgrade. You have completed this procedure. Go to one of the

following procedures:

Adding a PRI gateway (auto-discovered) on page 14

Adding a PRI gateway (not auto-discovered) on page 16

h. If the build number of the firmware version running on the gateway is an earlier build, then you need to prepare

for an upgrade:

i. Review the

information such as supported upgrade paths and may also contain details that were unavailable at the

time this procedure was created.

ii. In the Download tab, navigate through the 6.0 directories to locate the firmware image file. For example,

FVG_GT-v60-build0193-FORTINET.out.

iii. To download the firmware image file to your management computer, click HTTPS .

iv. Save the file on your management computer and take note of the location where you save the file.

3. Backup the configuration file:

a. In the web-based manager of the FortiVoice gateway, go to Dashboard .

b. In the Status tab, go to the System Information widget and the System configuration row.

c. Click Backup .

d. Save the file on your management computer and take note of the location where you save the file.

4. Upgrade the firmware:

a. In the System Information widget, go to the Firmware version row.

b. Click Update .

c. Locate the firmware file and then upload that file.

Your web browser uploads the firmware file to the gateway.

d. To confirm, click Yes .

The gateway installs the firmware and restarts.

e. To make sure that the FortiVoice gateway web-based manager reloads correctly and displays all changes,

clear the cache of your web browser and restart it.

5. Verify that the firmware is successfully installed:

a. In the System Information widget, go to the Firmware version row.

b. Make sure that the firmware version is the one that you upgraded to.

You have completed this procedure.

6. Go to one of the following procedures:

Adding a PRI gateway (auto-discovered) on page 14

Adding a PRI gateway (not auto-discovered) on page 16