Table of Contents
Advertisement
Preparing for the vulnerability scan job
160
Figure 1: Configuring the security model for local accounts authenticating remotely
4
Select Local Computer Policy.
5
Select Computer Configuration.
6
Select Windows Settings.
7
Select Security Settings.
8
Select Local Policies.
9
Select Security Options.
10
Double-click Network access: Sharing and security model for local accounts.
(Alternatively, right-click and select Properties.)
11
Select Class - local users authenticate as themselves.
12
Select OK.
The setting takes effect immediately, and must remain in effect for the duration of
the vulnerability scan for it to function correctly. However, if the target host is
connected to a domain and this policy conflicts with the domain or other security
model with higher precedence, the policy may be overridden during the next
Group Policy object refresh. For more information about on policy precedence and
policy object refreshes, see the help for the Microsoft Management Console.
13
After the vulnerability scan job completes, revert the setting configured in step 11.
To enable NetBIOS
1
Go to Start > Control Panel.
2
Double-click Network Connection.
3
Right-click Local Area Connection, and select Properties.
If this host has most than one connection, configure the connection through which
the vulnerability scan will connect.
4
In the area labeled, "This connection uses the following items:", select Internet
Protocol (TCP/IP).
5
Select Properties.
6
Select Advanced.
7
Select the WINS tab.
8
In the NetBIOS setting area, select Enable NetBIOS over TCP/IP.
FortiAnalyzer Version 3.0 MR7 Administration Guide
05-30007-0082-20080908
Tools
Advertisement
Table of Contents
